Related Manuals for Uhome UDZ1-150P/P
Summary of Contents for Uhome UDZ1-150P/P
- Page 1 Model: UDZ1-150P/P Dehumidifier Thank you very much for selecting this new model of dehumidifier, please read this Operation Manual carefully before installing and using this appliance. Please keep this Operation Manual properly for future reference.
- Page 2 2.One is a thick tube with an inner diameter of 9mm and a length of 1 meter. (This pipe is suitable for gravity drainage) Thank you very much for choosing our Uhome dehumidifier to take care of you and your family!
-
Page 3: Important Notice
Important Notice Thank you a lot for choosing Uhome's dehumidifier, let it be a member of your family to protect the health of the whole family. Please read the manual carefully before you use the dehumidifier, it will help you operate the machine better, so as to achieve the best effect and extend the life of the machine. -
Page 4: Important Safety Instructions
Important Safety Instructions Warning Carefully read the instructions before operating the unit. • This appliance is for indoor use only and intended for use in a domestic environment only. • Any other use is not recommended by the manufacturer and may cause fire, electrical shocks or other injury to user or property. - Page 5 Before moving the appliance,the water tank should be emptied. • The handle on the appliance is designed to aid in its movement and should not be used to • support the full weight of the dehumidifier. When carrying the unit, it should be kept upright and sufficiently supported from its base.
-
Page 6: How It Works
& How it works Location • TO REDUCE NOISE LEVELS: Place a piece of carpet or a rubber mat under the unit to reduce any vibrations while the unit is running. Our dehumidifier uses compressor technology to extract water from the environment. - Page 7 Product Overview Front Control panel Water tank lid Front panel Water tank handle Water-level window Castor Water tank...
- Page 8 Operation Instruction 1. Plug the power cord into a properly grounded 115 volt AC outlet. 2. To turn the unit on, press the ON/OFF button. The unit will run n the factory setting of AUTO mode and low fan speed. And the default dehumidification is 50%.And the unit will display the RH,if the room humidity drops to 50%, the machine will automatically shut down.
- Page 9 5.You can also press to change the fan speed to HIGH or LOW. The indicator light will show the setting you have selected. A higher fan speed will result in quicker moisture removal. Then to run the dehumidifier for a preset amount of hours, press ."0"...
-
Page 10: Removing Collected Water
Removing Collected Water There are three ways to remove collected water: 1. Use the bucket When the bucket is full, remove the bucket and empty it. Do not move the unit at this time otherwise water may spill on the floor. ... - Page 11 3.Continuous Drainage: Water can be automatically be emptied into a floor drain by attaching the dehumidifier to a water hose. • Cut off the power; • Unscrew the water cap counterclockwise and pull out the rubber water plug； • Connect the water pipe (Inner diameter * wall thickness * length= 9mm * 2mm * 100cm) to the drainage outlet.
- Page 12 Care and Cleaning & Storage Warning: Turn the dehumidifier off and remove the plug from the wall outlet before cleaning. 1. Clean the bucket Clean the bucket with water every two weeks. 2. Clean the air filter Clean the filter with potable water at least once every 30 days. (Notes: It must be air-dried naturally after cleaning.
-
Page 13: Troubleshooting
Troubleshooting (Before contact our customer service, review this list. It may save your time and expense. This list includes the most common occurrences that are not the result of defective workmanship or materials in this dehumidifier.) Issue Cause Solution When the unit is in dehumidifying mode it absorbs humid air from Hot or cold room and freezes it to reduce the humidity. -
Page 14: Technical Data
Technical Data UDZ1-150P/P MODEL POWER SOURCE 115V~60Hz MOISTURE REMOVAL(65°F,60%RH) 50 PINTS(23.6L/DAY) MOISTURE REMOVAL(80°F,60%RH) 70 PINTS(33.1L/DAY) MOISTURE REMOVAL(86°F,80%RH) 100 PINTS(47.3L/DAY) HIGHEST MOISTURE REMOVAL 150 PINTS(70.9L/DAY) INPUT POWER(65°F,60%RH) 520W TOTAL CURRENT 6.8A IEF(65°F,60%RH) 1.8L/kWh MOTOR FLA 0.46A MOTOR COMPRESSOR(RLA/LRA) 4.0A/23A R32/180g REFRIGERANT 5.0MPa...
Need help?
Do you have a question about the UDZ1-150P/P and is the answer not in the manual?
Questions and answers