Advertisement
Quick Links
Installation Manual
CBA electric duct heater
Suitable for 0-10V control
This manual is intended for the installer of the type CBA electric duct heater. The manual
contains important information on the operation and installation of the duct heater.
Landjuweel 25, 3905 PE Veenendaal | P.O. Box 416, 3900 AK
1
Veenendaal
t +31 (0)318 54 47 00 | info@orcon.nl | www.orcon.nl
Advertisement
Summary of Contents for Orcon CBA-160-16
- Page 1 This manual is intended for the installer of the type CBA electric duct heater. The manual contains important information on the operation and installation of the duct heater. Landjuweel 25, 3905 PE Veenendaal | P.O. Box 416, 3900 AK Veenendaal t +31 (0)318 54 47 00 | info@orcon.nl | www.orcon.nl...
- Page 2 Power (W) 2000 3000 2000 3000 Application The electric duct heater is suitable as an after heater for Orcon decentralized WTU units: - WTU-EC-E - WTU-EC-IE - WTU-EC-TA See Figure 2 for a schematic representation. Landjuweel 25, 3905 PE Veenendaal | P.O. Box 416, 3900 AK Veenendaal t +31 (0)318 54 47 00 | info@orcon.nl | www.orcon.nl...
-
Page 3: Installation
- terminal 9 (-) of the CBA to terminal 11 (GND) of the WTU - terminal 10 (+) of the CBA to terminal 10 (0-10V) of the WTU. Landjuweel 25, 3905 PE Veenendaal | P.O. Box 416, 3900 AK Veenendaal t +31 (0)318 54 47 00 | info@orcon.nl | www.orcon.nl... - Page 4 100°C. The only way to reset this protection is to press the button on top of the duct heater. Landjuweel 25, 3905 PE Veenendaal | P.O. Box 416, 3900 AK Veenendaal t +31 (0)318 54 47 00 | info@orcon.nl | www.orcon.nl...
- Page 5 Temperature protection is activated. 1. Air velocity too low through duct heater. Check filters, fans and ductwork of the system. Landjuweel 25, 3905 PE Veenendaal | P.O. Box 416, 3900 AK Veenendaal t +31 (0)318 54 47 00 | info@orcon.nl | www.orcon.nl...
-
Page 6: Warranty
Warranty 1. Orcon bv grants a two-year warranty on the CBA electric duct heater. The warranty period starts on the production date. The warranty expires if: a. the installation was not carried out according to the applicable regulations; b. the defects were caused by improper connection, improper use, or contamination of the duct heater;... - Page 7 Corrigo controller Connect the CBA to terminals 10 and 11 Figure 4 Wiring diagram WTU-EC-E/IE/TA Landjuweel 25, 3905 PE Veenendaal | P.O. Box 416, 3900 AK Veenendaal t +31 (0)318 54 47 00 | info@orcon.nl | www.orcon.nl...
- Page 8 B: Overheat protection, automatic reset C: Overheat protection, manual reset S: Fuse J:Interlock K:Relay Figure 5 Wiring diagram CBA; 1~ 230V Landjuweel 25, 3905 PE Veenendaal | P.O. Box 416, 3900 AK Veenendaal t +31 (0)318 54 47 00 | info@orcon.nl | www.orcon.nl...
Need help?
Do you have a question about the CBA-160-16 and is the answer not in the manual?
Questions and answers