Eco Spa E6 Owner's Manual

Hard cover spa

Advertisement

Quick Links

1
By: Fusion Pacific
The ORIGINAL Hard Cover Spa®
OWNER'S MANUAL - MODEL E6
IMPORTANT SAFETY INSTRUCTIONS INSIDE.
READ ENTIRE MANUAL BEFORE INSTALLING SPA.
PLEASE SAVE THIS MANUAL FOR FUTURE REFERENCE.
OWNER'S RECORD
Please record the following important information here for handy reference.
MODEL #: _________
SERIAL #: _____________________________________________
DATE PURCHASED: ________________________
PRICE PAID (BEFORE TAX): $______________
DATE INSTALLED: _______________________
DEALER NAME: _______________________________________________
DEALER ADDRESS: _____________________________________________
CITY ________________________STATE____ ZIP_________
DEALER TELEPHONE: _____________________________________
R.MARCH 01, 2024_B_GECKO_E6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the E6 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Eco Spa E6

  • Page 1: General Information Cover, Owner's Record

    By: Fusion Pacific The ORIGINAL Hard Cover Spa® OWNER’S MANUAL - MODEL E6 IMPORTANT SAFETY INSTRUCTIONS INSIDE. READ ENTIRE MANUAL BEFORE INSTALLING SPA. PLEASE SAVE THIS MANUAL FOR FUTURE REFERENCE. OWNER’S RECORD Please record the following important information here for handy reference.
  • Page 2: Factory Limited Warranty

    This warranty begins on date of delivery and it extends to the original purchaser of any model ECO SPA manufactured March 1, 2024 or later. If your ECO SPA develops a defect that is covered under the terms of this warranty, it will be repaired by ECO SPA or its authorized dealer.
  • Page 3: Table Of Contents

    ……….…………………………………….………………………………… INSTALLATION GUIDE PAGES 8 - 9 SETTING UP AND FILLING YOUR NEW ECO SPA ………………………………….………….……….…… PAGE 10 CARE AND MAINTENANCE INSTRUCTIONS ……………………………………………………….… PAGES 11 - 12 JET, COMPONENT AND EQUIPMENT OPERATING INSTRUCTIONS JET OPERATION – MASSAGE JETS ………………………………………………………..……………………..PAGE 13 AIR CONTROLS …………………………………………………………………………………..………………….…..
  • Page 4: Thank You, Helpful Hints

    Heating time can vary depending on ambient air temperature, but generally if operating on 110 Volts your ECO SPA will heat after fill-up at the rate of approximately 1.5° F per hour. If the spa is operating at 220 Volts heating time will improve considerably to a rate of approximately 3 °...
  • Page 5: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS WARNING Connect to a grounded, Grounding Type Receptacle Only. To reduce the risk of electric shock, replace damaged cord immediately. Do not bury the cord. DANGER To reduce the risk of injury to persons, do not remove Suction Fittings. TO REDUCE THE RISK OF INJURY: •...
  • Page 6 IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS DANGER: RISK OF ELECTRICAL SHOCK Do not permit any electric appliance such as a light, telephone, radio, or television within 5 feet of a spa or hot tub. WARNING: CHILDREN SHOULD NOT USE A SPA OR HOT TUB WITHOUT ADULT SUPERVISION. AVERTISSEMENT: NE PAS LAISSER LES ENFANTS UTILISER UNE CUVE DE RELAXATION SANS SURVEILLANCE.
  • Page 7 IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS WARNING: PREGNANT OR POSSIBLY PREGNANT WOMEN SHOULD CONSULT A PHYSICIAN BEFORE USING A SPA OR HOT TUB. AVERTISSEMENT: LES FEMMES ENCEINTES, QUE LEUR GROSSESSE SOIT CONFIRMEE OU NON, DEVRAIENT CONSULTER UN MEDECIN AVANT D’UTILISER UNE CUVE DE RELAXATION. WARNING: WATER TEMPERATURE IN EXCESS OF 40°...
  • Page 8: Installation Guide

    Please Read and Understand All Instructions Before Operating Your SELECTING THE INSTALLATION LOCATION Your new ECO SPA is completely self-contained. It can be set up on a patio, deck, or indoors with special consideration • Your ECO SPA must be installed on a relatively smooth, solid, flat and level surface that will support 3,000 pounds.
  • Page 9 • If you are going to operate your ECO SPA at 110 Volts your ECO SPA draws a maximum of 12 Amps operating at 110 Volts. A GFCI power cord is supplied with all 110 Volt models. • Locate the round plate labeled POWER CORD on the outside bottom corner of the rear side of the spa, remove it and pull out the electrical cord with the attached GFCI unit that is located behind this plate.
  • Page 10: Setting Up And Filling Your New Eco Spa

    ‘airlock’ and will make priming the pump easier. Fill your ECO SPA to an approximate water level of 2" above the top of the highest jet. Once the spa is filled to this level, power can then be supplied to your ECO SPA.
  • Page 11: Care And Maintenance Instructions

    CARE AND MAINTENANCE INSTRUCTIONS HARD COVERS & SPA SURFACES When not in use please keep your ECO SPA hard covers clamped down at all times, especially in extreme weather conditions. Consistent use of the clamps will help maintain the fit of the covers to the spa.
  • Page 12 WINTERIZING If your ECO SPA is to be transported or stored in temperatures 32º F (0º C) or lower, it is critical that your ECO SPA be fully winterized. The ECO SPA must be fully drained and emptied. (See DRAINING YOUR SPA, above) 1.
  • Page 13: Jet, Component And Equipment Operating Instructions

    MAY VARY FROM THIS MANUAL DEPENDING ON MANUFACTURER AVAILABILTY. JET OPERATION Your ECO SPA is designed with a versatile jet system to allow you to select a wide variety of massage patterns and tailor your ECO SPA to your specific massage and hydrotherapy needs.
  • Page 14: Diverter Valve

    SUCTION FITTINGS Keep the SUCTION FITTINGS (located in the foot well area) of the ECO SPA unobstructed and free from debris at all times. Do not remove the suction-fitting screen while the ECO SPA is connected to electrical power.
  • Page 15: Troubleshooting

    For a new 220 Volt installation or for an recently converted from 110 Volt to 220 Volt ECO SPA operation the problem is most likely with the wiring of the 220 Volt circuit’s GFCI breaker. If GFCI trips instantly the problem is usually the neutral wire path in the GFCI. For an...
  • Page 16 If operating on 110 Volts, your ECO SPA will only gain 1.5 degree per hour and will not heat with the pump on high speed. If operating on 220 volts, your ECO SPA will gain from 3 to 6 degrees per hour and will heat with the pump on low or high speed. Turn the Air Controls to Off and close the covers for most efficient heating.
  • Page 18: Wiring For 110/220 Volt Operation

    WIRING CONNECTIONS FOR 110 VOLT OPERATION POWER CONNECTIONS If your ECO SPA is wired for 110 Volt operation, the Control System (‘Pack’) power terminal block 3 wiring connections should look like this: HEATER CONNECTION For the heater to operate at 1 kW on 110 Volts the brown jumper wire’s yellow-jacketed spade lug is correctly and completely connected...
  • Page 19 Rotate the Dial to Elec. Config., then press & Rotate the Dial to Input Current Next, Rotate the dial to scroll thru various Breaker Settings: The Breaker Setting should be set at 16 if your ECO SPA was set at the factory for 110 Volt operation. If your ECO SPA was set at the factory to operate on 220 Volts the Breaker Setting will read 40.
  • Page 20: Warranty Registration Card

    By: Fusion Pacific The ORIGINAL Hard Cover Spa® Warranty Activation Card To enjoy the full benefits of your ECO SPA warranty, please fill out the form below completely and mail it with copy of your sales receipt or purchase agreement...

Table of Contents

Save PDF