Download Print this page

Rev-A-Shelf Omega National Verona Manual

Download this manual

Verona Range Hood

• Always read the instructions completely and carefully before beginning assembly.

• Remove and check contents for damage and/or missing parts. Keep the original

cartons and packing materials, which are required for any authorized adjustment by

our dealers.

• These instructions are for reference only. Make sure installation procedures comply

with all applicable building codes in your area.

Parts List

1 ea.- Hardware Pack

Important Notes

Form OME-119, 07/2024

Need help?

Do you have a question about the Omega National Verona and is the answer not in the manual?

Page 1 • These instructions are for reference only. Make sure installation procedures comply with all applicable building codes in your area. Parts List 1 ea.- Hardware Pack Form OME-119, 07/2024 ©Omega National Products by Rev-A-Shelf...
Page 2 Step 4: Start 6 each 10-24 x 3/4” screws into the “T” Figure 4 nuts that were previously installed, leaving them extending out slightly from the mounting board. (See figure 4). Form OME-119, 07/2024 ©Omega National Products by Rev-A-Shelf...
Page 3 These must be done in accor- dance with all applicable building codes and requirements in your area. If using Omega National Products Interior Ductwork Kit then see Form OME-14 Form OME-119, 07/2024 ©Omega National Products by Rev-A-Shelf...
Page 4 (See figure 9). Step 10: Fasten the metal liner to the Wood Range Figure 10 Hood at this time using 9 each #8 x 1/2” pan head screws (See figure 10). Form OME-119, 07/2024 ©Omega National Products by Rev-A-Shelf...