Download Print this page

Dacor AOCTK27 Installation Instructions

Dacor microwave oven installation instructions

Advertisement

Quick Links

INSTALLATION INSTRUCTIONS
For DACOR Built-in Kit Model AOCTK27 or AOCTK30
THIS KIT IS UL APPROVED TO ALLOW CERTAIN MICROWAVE OVENS TO BE INSTALLED ABOVE CERTAIN CONVENTIONAL/CONVECTION WALL OVENS.
PLEASE SEE THE OPERATION MANUAL REGARDING BUILT-IN APPLICATIONS.
IF YOUR LOWER CONVENTIONAL OVEN IS NOT LISTED IN THE OPERATION MANUAL OR THE INSTALLATION INSTRUCTIONS OF THE MICROWAVE OVEN
AS AN APPROVED MAKE AND MODEL, THEN DO NOT INSTALL THE MICROWAVE OVEN IN ANY AREA WHERE HEAT AND STEAM ARE GENERATED; FOR
EXAMPLE, NEXT TO OR ABOVE A CONVENTIONAL RANGE OR ABOVE A CONVENTIONAL WALL OVEN.
Microwave Oven: DCM24
Lower Oven: EO127, EO130, MOV127, MOH127, MOV130, MOH130, PO127, PO130
Do not build-in above any other gas or electric wall oven.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING INSTALLATION!
• Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the Built-in Kit.
Remove the turntable from the oven cavity.
• Because the kit includes metal parts, due caution should be used in handling and installation to avoid the possibility of
injury.
• Do not remove permanently affixed labels, warnings or plates from the product. This may void the warranty.
• Please observe all local and national codes and ordinances.
• The installer should leave these instructions with the consumer who should retain for local inspector's use and
for future reference.
PARTS INCLUDED IN THE KIT
1 FRONT FRAME
ASSEMBLY: QTY 1
2 BOTTOM DUCT:
QTY 1
3 SCREW-A (1/2"
LENGTH): QTY 10
4 SCREW-B (1
3
/
LENGTH): QTY 4
5 SCREW-C (1
/
3
LENGTH): QTY 2
"
4
"
16
6
DUCT-A1: QTY 1
7
DUCT-A2: QTY 1
8
DUCT-A3: QTY 1
9
DUCT-B: QTY 1
!
DUCT-C: QTY 1
CORD BOX: QTY 1
1

Advertisement

loading

Summary of Contents for Dacor AOCTK27

  • Page 1 INSTALLATION INSTRUCTIONS For DACOR Built-in Kit Model AOCTK27 or AOCTK30 THIS KIT IS UL APPROVED TO ALLOW CERTAIN MICROWAVE OVENS TO BE INSTALLED ABOVE CERTAIN CONVENTIONAL/CONVECTION WALL OVENS. PLEASE SEE THE OPERATION MANUAL REGARDING BUILT-IN APPLICATIONS. IF YOUR LOWER CONVENTIONAL OVEN IS NOT LISTED IN THE OPERATION MANUAL OR THE INSTALLATION INSTRUCTIONS OF THE MICROWAVE OVEN AS AN APPROVED MAKE AND MODEL, THEN DO NOT INSTALL THE MICROWAVE OVEN IN ANY AREA WHERE HEAT AND STEAM ARE GENERATED;...
  • Page 2 STEP 1 CABINET OR WALL OPENING CABINET OR WALL OPENING Provide an opening in the wall or cabinet as indicated on figure 1. The depth should be a minimum of 24". The floor of the opening should be constructed of plywood strong enough to support the weight of the oven (about 100 lbs.) and should be level for proper operation of the oven.
  • Page 3 Figure 4 SCREW-A STEP 3 CORD BOX 1. Plug the oven electrical cord into the CORD BOX RECEPTACLE and roll the remaining part of the cord into the CORD BOX as shown in Figure 6-A. 2. Remove screw #2 from lower left rear of the oven. Insert right flange of the CORD BOX into hold lip of the oven.
  • Page 4 CUTOUT CUTOUT CUTOUT CUTOUT 41" 41" 41" 41" DACOR INC. 1440 Bridge Gate Drive • Diamond Bar, CA 91765 1-800-793-0093 • www.dacor.com Figure 8 SCREW-B SCREW-C SCREW-B OVER WARMING OVEN INSTALLATION TOP OF TOP OF TOP OF TOP OF TOP OF...

This manual is also suitable for:

Aoctk30