Domus DUSK PATH Installation Manual

DUSK PATH
Specifications
Voltage: 12V DC
Power: 4W
CCT: 3000K-4000K-5000K
Requires: 12V DC Constant Voltage LED Driver (Wire in Parallel)
Save these instructions
Warning - To reduce the risk of fire or injury to persons:
• Turn power off or unplug the luminaire and allow it to cool before replacing the lamp
• Lamp gets hot quickly. Contact only switch/plug when turning on.
• Do not touch the hot lens, guard or luminaire housing until it has cooled
• Keep Lamp away from combustibles.
• Do not touch lamp. Use a soft cloth. Oil from skin may damage lamp.
• Do no operate the luminaire fitting with a missing or damaged shield.
Important Safety Instructions
• 12 Volt Fixture
• For outdoor use only
• Make sure the power is turned off before installing or servicing the luminaire.
• WARNING: Risk of electrical shock. Install all luminaires 3.05m or more from a pool, spa or fountain.
• Position the wire and wire connector so that it is connected within 15.2 cm from a building or structure, a luminaire or fitting.
• Not to be buried except for a maximum of 15.2 cm to connect the main low voltage cable.
Lamp Installation/Replacement Instructions
• Unscrew the clear section of the head from the metal base (see drawing below).
• Screw the post into the base of the head, Insert the G4/G5.3 LED lamp with correct wattage as marked on the fixture label.
• Re-assembly the head by rescrewing the clear section into the metal base.
Note:
-The lamp must be installed by professional electrician
-Ensure the power supply is switched off before fitting this product
29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
enquiries@domuslighting.com.au | www.domuslighting.com.au
Lumen (±5%): Warm White 3000K - 330lm
Neutral White 4000K - 350lm
White 5000K - 330lm
Beam Angle: 90°
CRI: ≥90
Phone: 02 9554 9600 | Fax: 02 9554 9433
Dimmable:
IP Rating:
Lifespan:
-Do not touch the lamp when in use
-Keep away from hot steam and corrosive gas
Installation Manual
Date: February 29, 2024 12:49 PM
No
IP65
50,000hrs