Related Manuals for Flue & Ducting Woodford 5 kW
Summary of Contents for Flue & Ducting Woodford 5 kW
- Page 1 Instructions WOODFORD Stove PLEASE RETAIN THIS GUIDE FOR FUTURE REFERENCE EN 13240:2011 +A2:2004 Booklet 723 Rev 02 ISSUE DATE : 27/07/2018...
- Page 2 Instructions WOODFORD Stove Woodford Stove Collection Congratulations on the purchase of your new stove! More than 30 years of experience has been put into the development of your stove to ensure ultimate performance and years of trouble free use and enjoyment. Every detail of your stove has been carefully designed and engineered which is why we are so confident in the reliability of our products.
-
Page 3: Table Of Contents
Instructions WOODFORD Stove Contents 1 Identifying your stove 1.1 Identifying parts & terminology of your stove—External..……….. 1.2 Identifying parts & terminology of your stove—Internal ………… INSTALLATION GUIDE 2 Warnings 2.1 Important Warnings ………………………………………………………. 3 Health & Safety 3.1 Health and Safety Practice……………………………………………….. 4 Installation Requirements 4.1 Hearth &... - Page 4 Instructions WOODFORD Stove 10 Before You Start 10.1 Pointers Before Use …………………………………………………... 11 Air Inlet Controls 11.1 Air inlet …………………………………………………………………. 11.1.1 Primary air control location………………………………………. 11.1.2 Primary air control …………………………………………………. 11.1.3 Secondary air control………………………………………………. 11.1.4 Tertiary air …………………………………………………………... 12 Lighting Your Stove 12.1.1 Smoke control areas ………………………………………………..
-
Page 5: Identifying Your Stove
Instructions WOODFORD Stove 1 Identifying your stove 1.1 Identifying parts & terminology of your stove—External Top Flue Outlet (NOTE : Top & Rear Flue Outlets Are Interchangeable & Will Depend Upon Fire Door Installation.) Assembly Stove Glove Fire Door (Packed Loose) Handle Operating Tool Air Controls... -
Page 6: Identifying Parts & Terminology Of Your Stove-Internal
Instructions WOODFORD Stove 1.2 Identifying parts & terminology of your stove—Internal Firebox Liners (Sides, Base & Rear) Fire Door Grate Glass (Riddling) Fuel Retainer Ash Pan Location Throat Plate Tertiary Outlet Within Rear Liner Riddle Lever Page 6 Booklet 723... -
Page 7: Installation Guide
INSTALLATION GUIDE 2 Warnings 2.1 Important Warnings It is a LEGAL REQUIREMENT that the installation of all new or replacement, wood or solid fuel heating appliance, obtain building control approval from your local authority or the installation work must be carried out through a government approved competent persons scheme. -
Page 8: Installation Requirements
INSTALLATION GUIDE 4 Installation Requirements 4.1 Hearths and Recesses The stove should be installed on a surface with adequate load bearing capacity. If the existing construction does not meet this prerequisite, suitable measures (e.g. load distributing plate) should be taken to achieve it. Please pay particular attention when examining existing building work for suitability to meet the following requirements. -
Page 9: Air For Combustion
INSTALLATION GUIDE 4.3 Air For Combustion All stoves require ventilation to burn safely and correctly. There are a number of requirements that need to be met when installing a stove, for example, allowing for the permeability of the house (air permeability is the general seepage of air into the house via air vents, doors and windows etc.) There must always be a permanent means of providing air for combustion into the room in which the stove is installed. -
Page 10: Flue & Chimneys
INSTALLATION GUIDE 5 Flue And Chimneys 5.1 Requirements The stove must be connected to a suitable and efficient flue so that products of combustion (fumes) from the stove are expelled to the outside air. Please remember that chimney draught is dependent on four main factors : •... -
Page 11: Installing The Stove
INSTALLATION GUIDE Check the existing flue is in good condition with suitable access for collection and removal of debris. It is also important that suitable flue pipe (recommended at least 600mm in length) complying with the Building Regulations is used to connect the stove to the flue in the chimney. -
Page 12: Fitting The Hot Plate (Blanking Plate)
INSTALLATION GUIDE 6.4 Fitting The Hot Plate (Blanking Plate) The hot plate or sometimes referred to as a blanking plate, will be supplied fitted to the rear outlet of the stove. Again this can be fitted to either outlet on the appliance and is dependent upon the installation requirements. -
Page 13: Control Areas)
INSTALLATION GUIDE 6.8 Smoke Control Area (The Clean Air Act 1993 & Smoke Control Areas) If the stove is to be installed in a designated Smoke Control Area (further information can be found via https://www.gov.uk/smoke-control-area-rules ) then the secondary air lever must be fitted with a restrictor plate to prevent total closure of the secondary air control. -
Page 14: Commissioning The Stove
INSTALLATION GUIDE 7 Commissioning the stove 7.1 Checklist Before handing over the installation to the customer it is a requirement under Document J (of the Building Regulations for England and Wales) that the appliance is lit and the functioning of the chimney system is checked for satisfactory operation. Be sure that the chimney is operating and all smoke and fumes are vented to the ... -
Page 15: User Guide
USER GUIDE 8 Warnings— IMPORTANT INFORMATION 8.1 Important Warnings It is a LEGAL REQUIREMENT that the installation of all new or replacement, wood or solid fuel heating appliance, obtain building control approval from your local authority or the installation work must be carried out through a government approved competent persons scheme. -
Page 16: Health & Safety
USER GUIDE 8.2 Health and Safety Please consult health and safety guidelines for advice on handling heavy and / or large items. 8.3 Smoke control areas (The Clean Air Act 1993 & Smoke Control Areas) Under the Clean Air Act local authorities may declare the whole or part of the district of the authority to be a smoke control area. -
Page 17: Recommended Fuels
USER GUIDE 9 Recommended fuels 9.1 Wood As a natural and renewable fuel, wood is the first choice for burning, however burning wood requires a little effort and planning. Any type of wood is suitable (though hardwood is preferable) provided it is well seasoned and has a moisture content below 20%. -
Page 18: Pointers Before Use
USER GUIDE 10 Before using your stove 10.1 Pointers Before Use Woodford stoves are designed to be operated with the fire door(s) closed at all times, apart from refuelling (when alight) or cleaning (when cold). Never leave the appliance unattended for an extended length of time with the door(s) open. -
Page 19: Air Inlet Controls
USER GUIDE 11 Air inlet controls 11.1 Air Inlet Your stove requires air to function, this enters the appliance via the circular duct at the rear of the stove. During installation, this circular duct can also act as the connection point for the direct air feed / ducting, depending upon the installation requirements. -
Page 20: Primary Air Control
USER GUIDE 11.1.2 Primary air control The primary air control regulates the air entering the fire box chamber, suppling air to the under side of the fuel bed. The control has an internal rotary plate with slots, housed inside the body of the appliance and is located below the right hand corner of the fire door assembly. -
Page 21: Tertiary Air
USER GUIDE The control has an internal rotary plate with slots, housed inside the body of the appliance and is located below the left hand corner of the fire door assembly, when looking at the front of the appliance. Sliding the control knob to the right, as far as it will go, achieves the fully open position, see figure 3. -
Page 22: Lighting Your Stove
USER GUIDE 12 Lighting your stove 12.1.1 Smoke control areas Please check whether your dwelling is located in a smoke control area before installation or use. Please check with your local authority or https://www.gov.uk/smoke-control-area- rules. 12.1.2 Fuel overloading The maximum amount of fuel specified in this manual should not be exceeded, overloading can cause excess smoke. -
Page 23: Burning Solid Fuel
USER GUIDE 12.3 Burning solid fuels Solid fuel burns best with its air supply for combustion coming from underneath the fuel. To achieve this, the burn will be controlled by the primary air control. A reduced setting may also be required on the secondary air control, to maintain clear glass on the door assembly. -
Page 24: Warning - Fume / Smoke Emissions
USER GUIDE 12.4 Warning - Fume / Smoke emissions Properly installed, with a suitable flue or chimney, operated and maintained correctly, this appliance will not emit fumes into the dwelling. Occasional fumes when de-ashing and refuelling may occur. However, persistent fume emission is potentially dangerous and must be investigated by an approved / registered installer. -
Page 25: Smoke Control Area
USER GUIDE 12.6 Smoke Control Area (The Clean Air Act 1993 & Smoke Control Areas) If the stove is to be installed in a designated Smoke Control Area (further information can be found via https://www.gov.uk/smoke-control-area-rules ) then the installer will have fitted the a restrictor plate for the secondary air lever to prevent total closure of this air control. -
Page 26: Further Information For All Stove Owners
USER GUIDE 13 Further information for all stove owners 13.1 Reduced burning (Slow Combustion) When wood is burnt slowly in a closed appliance (eg: air controls at the minimum setting), it produces moisture and tar, which will create condensation and deposits in the chimney. -
Page 27: Riddling The Firebox
USER GUIDE 13.5 Riddling the firebox To riddle the grate, the main fire door will need to be open, carefully open the fire door, using the stove glove supplied. Located the centrally mounted riddle lever, using the glove, move the lever left to right, repeatedly, until the ember / ash bed is has been reduced. -
Page 28: Replacement Parts
USER GUIDE Ashpan Operating Tool Fig. 7. Ash Pan 13.7 Replacement parts Genuine replacement spare parts can be obtained from your Flue & Ducting retailer / dealer. You can find a complete list of spares and consumables such as liners, replacement grate parts and throat plates as well as items to enhance its visual appearance and efficiency such as stove paint and rope kits. -
Page 29: Door Glass
USER GUIDE 13.10 Door glass The door glass should remain clear during normal burning. However under certain conditions, such as burning at a low or slow rate, using damp wood or overnight burning, the glass may become somewhat blackened. To remedy this, operate the appliance at a fast rate. -
Page 30: Care For Your Stove
USER GUIDE 14 Care for your stove The need for regular maintenance on your stove will ensure, safe and efficient use of your appliance. The following item listing should be checked and inspected by a competent person or engineer on a regular basis. PLEASE ENSURE THAT THE STOVE IS UNLIT AND COLD, BEFORE ATTEMPTING TO INSPECT THE BELOW ITEMS - 14.1 Adjusting the door hinges... -
Page 31: Fire Door Seal
USER GUIDE 14.4 Fire door seal The rope seal around the edges of the main fire door should also be checked. Look for signs of fraying, peeling away or the ends not meeting. If the rope is unable to create a good seal with the stove body it should be replaced. -
Page 32: Guarantee
USER GUIDE 16 Guarantee 16.1 Guarantee If any part of the main body of the stove fails due to a manufacturing or material defect during the guarantee period that applies in respect of the relevant stove (as set out below), Flue & Ducting Ltd will, at its sole discretion, repair or replace your stove, for no charge. -
Page 33: General
USER GUIDE 6. Any claims under this guarantee shall not be valid where the installation of the stove does not conform to all required building regulations and other legislation in force at the time of purchase and where flue draw readings have not been made to confirm a suitability of the flue. -
Page 34: Technical Data
TECHNICAL SPECIFICATION Woodford 5 kW TECHNICAL DATA Woodford 5 kW Woodford 7 kW Wide Height (mm) (On Std Fitted 585mm 600mm 600mm Feet) Width (mm) (Across Canopy) 457mm 522mm 522mm Depth (mm) (Inc. Handle Boss) 385mm 385mm 385mm Height To Centre Of Rear Flue 446.5mm... - Page 35 TECHNICAL SPECIFICATION Woodford 5 kW TECHNICAL DATA Woodford 5 kW Woodford 7 kW Wide Nominal Heat Output—Wood (Kw) Efficiency Nett (%) 79.8 Mean Flue Gas Temperature (°C) Mean CO Emission @ 13% O2 (%) 0.11 Flue Mass Gas Flow (g/s)
- Page 36 Instructions WOODFORD Stove flue&ducting Total Chimney Solutions All Woodford Stoves are manufactured in the UK Flue & Ducting Ltd Unit B, Herrod Avenue, Off Haigh Avenue , Whitehill Industrial Estate, Stockport, SK4 1NU United Kingdom www.woodfordcollection.co.uk T: +44 (0)161 480 2994 Email : sales@flue-ducting.co.uk DATE OF ISSUE—27/07/2018 Booklet 723...
Need help?
Do you have a question about the Woodford 5 kW and is the answer not in the manual?
Questions and answers