Table of Contents
Advertisement
Settings menu J
Buzzer
The buzzer has two volumes.
Normal (Factory default)
The buzzer sounds at the end of a
programme.
Loud
The buzzer sounds at maximum volume
at the end of a programme.
A tick L will appear beside the option
to show that it has been set.
Keypad tone
An audible tone sounds each time a
button is pressed.
A tick L will appear beside the option
to show that it has been set.
Factory default: Off.
Contrast
Brightness
There are ten different display
contrast and display brightness
settings.
The bar chart shows you the setting.
Factory default: a medium setting.
Standby display
To save energy, the display goes out
after 10 minutes and the indicator
light for the Start/Stop button will start
flashing slowly.
There are two options:
54
On
Standby is activated:
– if a programme is not selected within
10 minutes of the machine being
switched on.
– 10 minutes after a programme has
started.
– 10 minutes after the end of a
programme.
Not in current prog.
(Factory default)
– Standby is activated if a programme
is not selected within 10 minutes of
the machine being switched on and
after the end of a programme.
(Standby is not activated after a
programme has started).
Pressing one of the buttons switches
the display back on again.
A tick L will appear beside the option
to show that it has been set.
Memory
The electronics will memorise the
drying level and any extra options
selected for the current drying
programme.
A tick L will appear beside the option
to show that it has been set.
Factory default: Off.
Advertisement
Table of Contents
