TKH Siqura XSNet 4000SW Quick Start Manual

Quick Start Guide
This quick start guide describes how to install and use the Industrial Ethernet Switch. Capable of operating at temperature
extremes of -10°C to +60°C, this is the Switch of choice for harsh environments constrained by space.
Physical Description
The Terminal Block and Power input
DC Terminal Block Power Input: The DC Terminal Block power input can be used to power up this Switch.
The 10/100Base-TX and 100Base-FX/BX Connectors
The 10/100Base-TX Connections
The following lists the pinouts of 10/100Base-TX ports.
The 100Base-FX Connections
The fiber port pinouts
The Tx (transmit) port of device I is connected to the Rx (receive) port of device II, and the Rx
(receive) port of device I to the Tx (transmit) port of device II.
The WDM 100Base-BX Connections
The fiber port pinouts
Only one Single mode or Multi mode optical fiber is required to transmit and receive data.
Important: Note that XSNet Series manuals may cover multiple models. To
establish if a particular feature or specification in this manual applies to the
unit at hand, consult the datasheet of the given model.
The Terminal Block
PWR Power Input
GND Power Ground
Earth Ground
Pin Regular Ports
1 Output Transmit Data +
2 Output Transmit Data -
3 Input Receive Data +
4 NC
5 NC
6 Input Receive Data -
7 NC
8 NC
1
XSNet 4000SW
Note: The EU Declaration of Conformity for this product
can be found at www.siqura.com/support-files.
Uplink Port
Input Receive Data +
Input Receive Data -
Output Transmit Data +
NC
NC
Output Transmit Data -
NC
NC
V2