• disease, and bleeding disorders. 1.Safety Instructions • infection and AIDS). • If you are receiving or have received in the last couple of months radiotherapy or the user manual carefully. chemotherapy. Warning Warning DO NOT • This device is not a toy, keep out of reach of children. •...
Page 4
When using this device, ensure you (and other people in the same room) do ALWAYS use DO NOT cover the vent during use. DO NOT This is not a toy, the charging cord could lead to strangulation. DO NOT Water and electricity are a dangerous combination! To avoid risk of electrocution. This device is for single patient reuse.
Page 5
3.1. General introduction regulations for separate collection after its useful life Device Name: Intense Pulsed Light (IPL) System This device has not been tested Model: T033KW 3.2. Indications for use manual Manufacturer Wear eye protection 3.3. Introduction of device 3.3.1.
Page 6
3.3.2. Device picture Status of Flash When Graphical Ready Light representation Light on 1、 the skin. ⑤ ① ⑥ ⑦ ② Device probe fully contact the skin and ③ device is ready to trigger a flash, but ④ yet. the skin. ⑧...
Page 7
Picture 4: • Powered OFF: 2 seconds, mode indicator, Device probe • Intensity Level Adjustment: Plug Level 1 Level 2 Level 3 Level 4 connector • Manual Emit Flash mode: (2). Powered on: : Press and hold the button the device (3).
Picture 8 • • • treatment pulses. Press the button " " • Mode switch: • blinking. 4.2. Skin Test Patch • Auto Emit Flash mode: a)Turn on the device, select the intensity level 1, press the Device probe on the skin b)Wait 24 hours and check your skin for any reaction such as discomfort or pain.
Page 9
use it, if it is abnormal, please stop using it. Darker skin tones absorb more light easily causing skin irritation. Therefore, persons setting according to your pain sensation. steps a) to c). any discomfort (or pain). Example: You can increase the intensity to level 2 and SKIN Tone: The product is suitable for the skin tone in Type I to Type IV.
Page 10
Figure 10 4.4. Using Steps • • Press the Device probe on the skin, ensuring the Device probe is fully in contact completely dry the skin and remove any oily substances (such as body fragrance, lotion, perfume, sunscreen, and other cosmetics). Figure 11 •...
Page 11
adapter 20 minutes. 6. Cleaning & Maintenance Caution 1. After using the device, DO NOT apply any fragrant skin care or cosmetic product 6.1. Cleaning on your skin. 2. DO NOT use deodorant immediately after using the device on the armpits. Wait until the skin redness completely disappears to start using deodorant.
Page 12
6.2. Maintenance • correctly connected. cable. The device does not carefully protected. The Device probe is not Device Probe on your skin • DO NOT close enough to the skin. • DO NOT clean the device During use the device 7.
Device Name Intense Pulsed Light (IPL) System adverse skin reactions. Model T033KW If your body hairs are blonde, Your skin tone and hair The treatment results Dimension color are not suitable to are not satisfactory.
Page 14
12. Frequently Asked Questions Operating environment condensation Storage and transportation device is too high, please restart device after 10 minutes. environment condensation Q: What is cooling care function? Warranty period Applied part transfer process. Mode of operation: continuous Q: Must I shave hair before each use? Item Parameters Q: Why my hair still growing after few times treatment? Why it is not falling...
Page 15
Q: Which level is suitable? 13. Important Information Regarding Electro Magnetic Compatibility (EMC) more obvious the treatment effect is and the shorter the treating time is. On the Warning: is recommended to do local skin tests on the treated skin part before each hair removal, and then start treatment on large skin areas after, making sure that no skin cause malfunction or lead to loss of essential performance.
Page 16
The device is suitable for use in all should be that of a establishments, including domestic and those directly connected to the Signal lines. or a Professional healthcare facility environment. Voltage fluctuations and should be that of a Applicable magnetic resonance imaging. Surges Table 2 or a Professional...
Page 17
should be at levels communications table characteristic of a or a Professional healthcare facility environment. Test Maximum Immunity Band Distance frequency Service Modulation power Test Level Pulse Voltage dips should be that of a Applicable modulation or a Professional cycle Single healthcare phase: at 0°...
Page 18
WLAN, recommended separation distance d in meters (m) can be estimated using the Pulse modulation manufacturer. range applies. WLAN Pulse modulation people. table 4 Recommended separation distances between portable and mobile RF communication equipment and The device can help prevent electromagnetic interference by maintaining a minimum distance the device as d = 1.2 d = 1.2...
Operation Record Operation Record Operation site: Level: Operation site: Level: ______________ ____________ ______________ ____________ Date Remark Date Remark Operation Record Operation Record Operation site: Level: Operation site: Level: ______________ ____________ ______________ ____________ Date Remark Date Remark...
Need help?
Do you have a question about the T033KW and is the answer not in the manual?
Questions and answers