Advertisement
OPERATOR'S MANUAL
This manual provides information on
installation, operating, maintenance,
trouble shooting & replacement parts for
LOW PROFILE
EQUIPMENT STANDS
20000 SERIES
NOTIFY CARIER OF DAMAGE AT ONCE.
It is the responsibility of the consignee to inspect the
container upon receipt of same and to determine the
possibility of any damage, including concealed
damage.
Unified Brands suggests that if you are
suspicious of damage to make a notation on the
delivery receipt. It will be the responsibility of the
consignee to file a claim with the carrier.
We
recommend that you do so at once.
10/15/2013
PP MNL0503 rev C
Advertisement
Table of Contents
Summary of Contents for Unified Brands Randell 20000 Series
- Page 1 Unified Brands suggests that if you are suspicious of damage to make a notation on the delivery receipt. It will be the responsibility of the consignee to file a claim with the carrier.
-
Page 2: Table Of Contents
18-21…………………………….……..Replacement Parts Congratulations on your recent purchase of Randell food service equipment, and welcome to the growing family of satisfied Unified Brands customers. Our reputation for superior products is the result of consistent quality craftsmanship. From the earliest stages of product design to successive steps in fabrication and assembly, rigid standards of excellence are maintained by out staff of designers, engineers, and skilled employees. -
Page 3: Serial Number Location
In addition, all Randell food service equipment is backed by some of the best warranties in the food service industry and by our professional staff of service technicians. Retain this manual for future reference. NOTICE: Due to a continuous program of product improvement, Unified Brands reserves the right to make changes in design and specifications without prior notice. - Page 4 Warranty Policies Unified Brands believes strongly in the products it builds and backs them with the best warranty in the industry. Standard with every unit comes the peace of mind that this unit has been thoroughly engineered, properly tested and manufactured to excruciating tolerances, by a manufacturer with over 35 years of industry presence.
- Page 5 2. Provide repair at the manufacturing facility by requiring that the defective unit be sent back to Unified Brands freight prepaid. Perform repair at the expense of Unified Brands and ship the item back to the customer freight collect. 3. Furnish complete condensing unit freight collect in exchange for the return of the defective compressor sent back freight prepaid.
- Page 6 Verbal quotations are provided for customer convenience only and are considered invalid in the absence of a written quotation. Written quotations from Unified Brands are valid for 30 days from quote date unless otherwise specified. Unified Brands assumes no liability for dealer quotations to end- users.
- Page 7 PENALTY CLAUSES Dealer penalty clauses, on their purchase order or contractually agreed to between the dealer and their clients are not binding on Unified Brands. Unified Brands does not accept orders subject to penalty clauses. This agreement supersedes any such clauses in dealer purchase orders.
-
Page 8: Unit Specifications
Unit Specifications 20072SC shown 12x20x4 Ship Model Drawers H.P. Volts Amps NEMA Capacity Self Contained 20048SC 48" 32.5" 26" (2)27"ext. 5-15P 20048SC-C4 48" 32.5" 24" (2)27"ext. 5-15P 20072SC 72" 32.5" 26" (4)27"ext. 5-15P 20072SC-C4 72” 32.5” 24” (4)27”ext. 5-15P 20078SC 78”... -
Page 9: Unit Installation
Adjusting bullet feet heights or shimming casters may be necessary if the floor is not level. NOTE: Damage to equipment may result if not followed. Unified Brands is not responsible for damage to equipment if improperly installed. 4. Plug in unit and turn on main on/off power switch. - Page 10 8. Allow your unit to operate for approximately 2 hours before putting in food to allow interior of unit to cool down to storage temperature. NOTE: All motors are oiled and sealed. NOTE: FAILURE TO FOLLOW INSTALLATION GUIDELINES AND RECOMMENDATIONS MAY VOID THE WARRANTY ON YOUR UNIT. ELECTRICAL SUPPLY: The wiring should be done by a qualified electrician in accordance with local electrical codes.
-
Page 11: Electrical Diagrams
Electrical Diagrams www.unifiedbrands.net... -
Page 12: Unit Operation
Unit Operation Randell has attempted to preset the cold controls to ensure that your unit runs at an optimum temperature, but due to varying ambient conditions, including elevation, food product as well as type of operation, you may need to alter this temperature. - Page 13 To adjust the temperature in freezer units: A. Push and hold the “set” button until 12 appears and then release the “set” button. 12 is the current set point temperature. NOTE: Standard freezer units are preset to operate at 12° F. B.
-
Page 14: Preventive Maintenance
Preventive Maintenance Unified Brands strongly suggests a preventive maintenance program which would include the following Monthly procedures: 1. Cleaning of all condenser coils. Condenser coils are a critical component in the life of the compressor and must remain clean to assure proper air flow and heat transfer. - Page 15 NOTE: Do not pressure wash equipment as damage to electrical components may result. DRAWER REMOVAL AND INSTALLATION Drawer Removal: To remove the individual drawer: 1. Fully extend the drawer that is to be removed. 2. Remove product pans from drawer. 3.
- Page 16 These services often offer guarantees as well as the flexibility in scheduling or maintenance for your convenience. Unified Brands believes strongly in the products it manufactures and backs those products with one of the best warranties in the industry. We believe with the proper maintenance and use, you will realize a profitable return on your investment and years of satisfied service.
- Page 17 Unit too cold 1. Temperature control set too low 1. Adjust control to raise setting 2. Temperature control faulty 2. Test control Unit doesn’t defrost 1. Defrost heater faulty 1. Test defrost heater Moisture around drawer or frame 1. Breaker strips faulty 1.
- Page 18 20000 Series Replacement Low Profile Equipment Stands Parts 800-621-8560...
- Page 19 www.unifiedbrands.net...
- Page 20 ITEM DESCRIPTION PART # Drawer Front, 27”, Top RP FRT05T Drawer Front, 19”, Top RP FRT118 Drawer Front, 32”, Top RP FRT35T Drawer Front, 27”, Bottom RP FRT05B Drawer Front, 19”, Bottom RP FRT119 Drawer Front, 32”, Bottom RP FRT35B Sculptured Handle, 12-13/16”...
- Page 21 Evaporator Coil RP COI107 Evaporator Coil Assembly, Refrigerated Units only RP CSY0401 Evaporator Coil Assembly, Freezer Units only RP CSY0402 Shield Panel for Coil Assembly RP PNL107 Power Cord, Male 9’ EL WIR461 Rocker On/Off Switch EL SWT0502 Power Cord, Female 12” EL WIR469 Compressor, 20048SC RF CMP010-134...
Need help?
Do you have a question about the Randell 20000 Series and is the answer not in the manual?
Questions and answers