A-Tach 50582 Quick Start Manual

A-Tach # 50582
Designed for: Ford EcoSport 2018 - 2022
Once the mount and holder are screwed together, the items are considered used and non-refundable.
For best results, attach the mount or hold the mount over the place where the mount attaches to the dash
BEFORE attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most
often the mount will appear to be a little too big or small for the intended location. Once attached, the
mount should remain attached until you would like to permanently remove it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
Online instruction can be found on the product page – Or at link:
https://www.atachmounts.com/assets/images/PDF%20-%20Instructions/50582%20-%20Instructions.pdf
(1) Clean the area where the mount will attach. The upper
edge of the mount will attach onto the top center vent
frame illustrated with the arrow in the photo above.
(3) Remove the covering from the tape. Press the top of the
mount forward and upward onto the top vent frame so
both taped surfaces touch the vent frame.
NOTICE: The product has been tested to fit securely
to the listed vehicles. Instructions are provided for
your convenience. You are responsible for the use of
the product and to determine if you have the skill to
attach the product without causing damage to your
vehicle or the product.
A-Tach Mounts will not be responsible for any damage
to the vehicle due to the installation and/or use of the
product.
Read all instructions and view the photos before
attaching this product.
(2) The Lower edge of the mount will attach onto the
bottom center vent frame illustrated with the arrow in
the photo above.
(4) Press upward and forward on the lower edge of the
mount until the notched lower edge clicks into place on
the lower vent frame. The tape will not leave any residue if
the mount is removed in the future.
A-Tach
Mounts