Safety These instruction contains information that you must observe for your personal safety and to prevent personal injury and damage to property. They are highlighted by warning triangles and shown below according to the degree of danger. ► Read the instructions completely before start-up and use. This will help you to avoid hazards and errors.
Never break or puncture the Battery. Only charge the Battery in well ventilated rooms. Only use the original TQ Charger (FSP235-14S4AC8C) to charge the Battery. Use only original HPR Batteries to supply power to the drive system.
Page 4
The vapors may irritate the respiratory organs. 1.2.2 INSTRUCTIONS PERTAINING TO ELECTRIC SHOCK The Electric risk and shock is only applicable for the TQ Charger (FSP235-14S4AC8C). Please check and read all safety instruction which are included in the Charger manual. SAVE THESE INSTRUCTIONS...
Any other use or use that goes beyond this is considered improper and will result in the loss of the warranty. In case of non-intended use, TQ-Sys- tems GmbH assumes no liability for any damage that may occur and no warranty for proper and functional operation of the product.
Technical data Nominal voltage 50.4 V Nominal capacity 6.8 Ah Nominal energy 360 Wh Dimensions 48 mm x 63.5 mm x 370 mm / 1.89” x 2.5” x 14.57” Charging temperature 0 °C to 40 °C / 32 °F to 104 °F Operating temperature -5 °C to 40 °C / 23 °F to 104 °F Storage temperature...
OPERATION Battery charging DANGER ► Only use TQ Charger (FSP235-14S4AC8C) for charging the Battery. WARNING Fire or electric shock hazard due to damage to Battery, Range Extender, charger, cable and plug ► Never charge the Battery if you notice any damage to the Battery, Range Extender, charger, cables or connectors.
Page 8
NOTE You can charge the Battery either directly with the charger or via the optional Range Extender. For more information, refer to the corresponding user manuals for the charger and the Range Extender. ► Connect the charger to the power supply.
Page 9
— For transport observe the special requirements for packaging and labeling that apply in your country. — Contact a TQ authorized bicycle dealer for information on transporting the Battery and suitable transport packaging. For transport outside the bicycle frame, we recommend a certified transport box.
— Never immerse the Battery in water to clean it. — Never clean the Battery with a water jet. — Only clean the Battery with a soft, damp cloth. — Please contact a TQ authorised bicycle dealer, if the Battery is no longer functional. EN - 10...
BMS Reset If you want to reset the software of the battery management system for the purpose of re-use, preparation, repurposing or remanufacturing according to article 14 of REGULATION (EU) 2023/1542, please contact TQ-Systems GmbH via the following e-mail address: ebike@tq-group.com...
Page 12
NOTE For more information and TQ product manuals in various language, please visit www.tq-ebike.com/en/support/manuals or scan this QR-Code. We have checked the contents of this publication for conformity with the product described. However, deviations cannot be ruled out so that we cannot accept any liability for complete conformity and correctness.
Need help?
Do you have a question about the HPR Battery V01 360 Wh and is the answer not in the manual?
Questions and answers