Huawei SmartGuard 63A T0 SmartGuard 63A AUTO Quick Manual

SmartGuard
63A-(T0, AUT0)
Quick Guide
EN
快 速 指 南
ZH
Scan for support
扫码获取支持
Before installing the equipment, read the user manual carefully to get familiar with product
information and safety precautions. The product warranty does not cover equipment damage
caused by failure to follow the storage, transportation, installation, and usage guidelines specified
in this document and the user manual. Scan the QR code on the equipment to view the user manual
and safety precautions. The information in this document is subject to change without notice. Every
effort has been made in the preparation of this document to ensure accuracy of the contents, but all
statements, information, and recommendations in this document do not constitute a warranty of any
kind, express or implied.
安装设备前请详细阅读用户手册，了解产品信息及安全注意事项。未按照本文档与用户手册的内容存储、搬
运、安装和使用设备而导致设备损坏，不在设备质保范围内。您可以扫描机身处的"扫码获取支持"二维码，
查阅用户手册和安全注意事项等信息。由于产品版本升级或其他原因，本文档内容会不定期进行更新。除非
另有约定，本文档仅作为使用指导，文档中的所有陈述、信息和建议不构成任何明示或暗示的担保。
Issue: 02 Part Number: 31500JUP
Installation Requirements
文档版本: 02 部件编码: 31500JUP 1
安装要求
2 Loads Connected to the SmartGuard
负载分类接入备电盒
Main circuit breaker
入户总开关
All loads connected
1
全部负载接入备电盒
Loads not connected
不接入备电盒负载
Installing the Device
3
安装设备
If the power of backup loads exceeds the maximum off-
EN
grid power of the system, the inverter may shut down
due to overload. In this case, you need to shut down
some loads or connect unimportant loads to the non-
backup load port.
备电负载的功率超过系统离网运行最大功率，逆变器可能会
ZH
过载关机，需要关闭一些负载才能离网运行。或者将不重要
负载接入非备电端口。
Some loads connected
2
部分负载接入备电盒
4
Installing a PE Cable
安装保护地线
EN Apply silicone grease or paint for protection
ZH 建议涂抹硅胶或刷漆进行防护。
Opening the Maintenance Compartment
5
打开维护腔
Preparing AC Power Cables
6
准备交流线缆
Preparing Signal Cables
7
准备信号线缆
.