Advertisement
Quick Links
Advertisement
Summary of Contents for rako RAK-LINK-1GPK
- Page 1 Instruction Manual RAK-LINK-1GPK Replacement Power Supply Kit 2024 Version 2.0.0...
- Page 2 Rako Wired network to the top board. Power supply The 15V DC power supply powers the Rako Wired network, the board consists of a 230V AC input on the right and a 15V DC output on the left.
-
Page 3: Installation
The punch-down connector may have one or more CAT5 or CAT6 cables, leave them connected to the top board. Remove the ribbon cable STEP 3 and set it aside. Disconnect the RJ45 cable. RAK-LINK-1GPK Manual Version 2.0.0... - Page 4 Screw the replacement STEP 6 bottom board to the bottom tray and connect the DC plug to the left side of the power supply. RAK-LINK-1GPK Manual Version 2.0.0...
- Page 5 RAK-LINK ready to connect to the top board. Replace the top tray of the STEP 9 RAK-LINK, and reconnect the ribbon cable for the top board, this will join the top and bottom sections. RAK-LINK-1GPK Manual Version 2.0.0...
- Page 6 Tighten the four screws to fix STEP 10 the top and bottom panels in place. Screw the cover back on and STEP 11 power up the RAK-LINK. No programming is required after a power supply change. RAK-LINK-1GPK Manual Version 2.0.0...
Need help?
Do you have a question about the RAK-LINK-1GPK and is the answer not in the manual?
Questions and answers