Table of Contents
Advertisement
Configure Connection 1 for DHCP for WAN
Dynamic Host Configuration Protocol (DHCP) allows the gateway to automatically obtain the IP address from a
DHCP server on the service provider's network. The service provider assigns a global IP address from a pool of
addresses available to the service provider. Typically the IP address assigned has a long lease time, so it will
likely be the same address each time the Router requests an IP address.
Figure 3-9. Setup – Configure Connection 1 for DHCP service for the WAN
To configure the WAN connection for DHCP, perform the steps listed below. Some of the settings do not need
to be changed the first time the device is set up, but can be changed later if you choose.
1.
Click the Connection 1 button under WAN Setup to view the default PPPoA Connection Setup
configuration menu.
2.
Select DHCP from the Type: pull-down menu. This action will change the menu so it offers different
settings for configuration.
3.
Type in a Name: in the space provided (conn_1_DHCP_8_35 is used in the above example).
4.
If you are told to change the VPI or VCI values, type in the values given to you by your service
provider. Many users will be able to use the default settings.
5.
Leave the default QoS values if you are unsure or the ISP did not provide this information.
6.
Do not change the PCR or SCR values unless you are required to do so. If you are told to change these,
type in the values given to you by your service provider.
7.
The Encapsulation values LLC (SNAP) and VC (MUX) are two different methods of encapsulating
the PPP packet. Contact your ISP to make sure which encapsulation is being supported.
DSL-564T ADSL Router User's Guide
25
Advertisement
Table of Contents
