Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Iconix FX1+
Summary of Contents for Iconix FX1+
-
Page 3: Table Of Contents
CONTENTS SYSTEM CARE ..........................3 Essential Care ..........................3 Site Preparation ..........................3 OPERATING INSTRUCTIONS ......................4 Getting Started ..........................4 Weigh Key ............................5 Delete Key ............................5 Stats Key ............................5 Clearing Statistics........................5 Battery Voltage ..........................5 SET-UP KEY ..........................6 SPECIFICATIONS .........................7 Steel Loadbar Set 2000kg ......................8 Heavy-Duty Loadbar Set 3500kg ....................8... - Page 4 The information in this manual may be changed without notice and should not be construed as a commitment by Iconix New Zealand Ltd. Great care has been taken in preparing this manual, however Iconix New Zealand Ltd assumes no responsibility for any technical inaccuracies or typographical errors.
-
Page 5: System Care
1. SYSTEM CARE The FX1+ weighing system has been designed to work reliably for long periods of time under adverse conditions. However like any equipment, common sense and care will assist in keeping it in good operating condition. ESSENTIAL CARE ... -
Page 6: Operating Instructions
Connect the two loadbar cables to the loadbar sockets marked on the rear of the indicator. Either: Use the Iconix AC adaptor Attach the battery cable to the FX1+ and clip onto a 12V DC battery (car, tractor battery ―... -
Page 7: Weigh Key
WEIGH KEY To weigh an animal on the scale, press WEIGH – press in the centre of the cursor button. The animal is accurately weighed and the result locked on the display (in HOLD mode). Statistics are updated (if enabled in Set-Up). For a complete description of the weighing process, see the GETTING STARTED section above. -
Page 8: Set-Up Key
3. SET-UP KEY NOTE: Most FX1+ settings apply only to the currently connected scale e.g. standard loadbars on Scale 1. Changing these settings has no effect on the other two scales. Some settings apply to all possible scales (1: standard loadbars, 2: vet or other scale base, 3: heavy-duty loadbars). -
Page 9: Specifications
4. SPECIFICATIONS FX1+ Version 3.03 onwards (P3.03 is shown at switch-on), 2021 onwards. Supply Voltage: Nominal ..12V DC Maximum ..19V DC Reverse polarity protection diode fitted. Low Battery Indication: Below approximately 11.6V the LOW BAT pointer will be on. ... -
Page 10: Steel Loadbar Set 2000Kg
STEEL LOADBAR SET 2000kg HEAVY DUTY LOADBAR SET 3500kg Page 8 FX1+ Manual v3.07 28Feb24... - Page 11 23 Matipo Street, Palmerston North, New Zealand Ph 64-6-3501528 www.iconix.co.nz...
Need help?
Do you have a question about the FX1+ and is the answer not in the manual?
Questions and answers