matson MA35000 Owner's Manual

12/24v lithium jump starter

Advertisement

MA35000
12/24V LITHIUM
JUMP STARTER
MANUAL
MA35000
MA35000
MANUAL
12/24V
LITHIUM JUMP STARTER
MANUAL
| 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MA35000 and is the answer not in the manual?

Questions and answers

Summary of Contents for matson MA35000

  • Page 1 MA35000 12/24V LITHIUM JUMP STARTER 12/24V LITHIUM JUMP STARTER MANUAL MA35000 MANUAL MA35000 MANUAL...
  • Page 2: Product Layout

    12/24V LITHIUM JUMP STARTER To avoid any personal injury, please read the safety instructions below. This manual contains important safety and operating instructions for the MA35000 Jump Starter. Consider ALL safety, warning and caution WARNING instructions carefully. PRODUCT LAYOUT Voltage Select...
  • Page 3 2. For a strobe light, briefly press the Main Power Button again. The screen will show “FLASH” 3. For an SOS signal light, briefly press the Main Power Button again. The screen will show “SOS” 4. To turn off the light, press the Main Power Button again MA35000 MANUAL...
  • Page 4: Jump Starting A Vehicle

    RUNNING/CHARGING 12V DC APPLIANCES The MA35000 can supply 12V DC power at a maximum of 10amps from the cig socket on the side of the jump starter to power devices such as compressors, coolers and OBDII memory savers etc.
  • Page 5 Disconnect the clamps immediately and reconnect correctly, then resume jump starting. B) If the screen shows “WARNING CLAMPS REVERSED CHECK ALL CONNECTIONS” the jump start clamps are connected in reverse polarity. Remove the clamps immediately, re-connect correctly and resume jump starting. MA35000 MANUAL...
  • Page 6: Using The Override Button

    9. Once the engine has started, immediately remove the BLACK/negative (-) clamp first, then the RED/positive (+) clamp 10. Recharge the jump starter before storing MA35000 MANUAL...
  • Page 7: Technical Specifications

    USB output or 12V DC Protection mode has tripped, disconnect all Display screen is blank output overloaded, or there devices, wait two minutes for unit to re-set, then is a short circuit re-try. Check devices are in good condition MA35000 MANUAL...
  • Page 8: Warranty Policy

    You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. Tridon Australia will bear costs associated with claiming legitimate warranties. Proof of expenses incurred must be submitted to Tridon Australia Pty Ltd. MA35000 MANUAL...

Table of Contents