Rutus SR-1 Instruction Manual

RUTUS SR–1
WIRELESS
HEADPHONES
The SR–1 headphones operates in three connection modes:
1. Wireless Direct – headphones working with the Versa and Atrex metal detectors, connects
using a direct radio link
2. Wireless Bluetooth – Bluetooth headphones
3. Wired – standard wired headphones using the included cable and the 3.5mm socket in the
headphones
Getting started
To begin the setup of headphones, please ensure headphones are fully charged. NOTE: The
Bluetooth module has priority over the radio module. This means that if the Bluetooth module is
turned on (the LEDs on the headphones are blinking or on), cooperation with the detector is not
possible. The type of mode is selected when the headphones are turned on – use the
multifunction On/Off (3) button to select the required mode. If you want to use the headphones in
cooperation mode with the detector, make sure that the Bluetooth module is turned off. Briefly
pressing the On/Off button (3) until you hear a single–tone signal turns on the radio module to
cooperate with the detector. Pressing and holding the On/Off button (3) until you hear four
increasingly higher sounds turns on the Bluetooth module.
Charging headphones
Connect the USB charging cable to the charging USB socket of the headphones. The LED
indicator keeps red while charging, and it will turn off once it is fully charged.
INSTRUCTION MANUAL
1 – LED indicator
2 – Volume + / next track
3 – Multifunction button
On/Off
4 – Volume – / previous track
5 – 3.5 mm audio jack
6 – Microphone
7 – USB charging port