Connect Using Wcn 2.0 In Windows Vista - D-Link DIR-615 User Manual

Section 5 - Connecting to a Wireless Network

Connect Using WCN 2.0 in Windows Vista

™
The router supports Wi-Fi protection, referred to as WCN 2.0 in Windows Vista ™ . The following instructions for setting
™
this up depends on whether you are using Windows Vista to configure the router or third party software.
When you first set up the router, Wi-Fi protection is disabled and unconfigured. To enjoy the benefits of Wi-Fi protection,
the router must be both enabled and configured. There are three basic methods to accomplish this: use Windows Vista's
built-in support for WCN 2.0, use software provided by a third party, or manually configure.
™
If you are running Windows Vista , log into the router and click the Enable checkbox in the Basic > Wireless section.
Use the Current PIN that is displayed on the Advanced > Wi-Fi Protected Setup section or choose to click the Generate
New PIN button or Reset PIN to Default button.
For additional information, please refer to page 47.
If you are using third party software to set up Wi-Fi Protection, carefully follow the directions. When you are finished,
proceed to the next section to set up the newly-configured router.
D-Link DIR-615 User Manual 79