Page 2
2111907AU 82TB20 BIKE HANDLE TRIMMER & BRUSH CUTTER OPERATOR MANUAL Greenworks Australia A Division Jak Max P/L 380 Foley’s Road Derrimut Victoria, Australia 3026 STB414 www.greenworksaustralia.com...
English Start the machine........8 Description........2 Stop the machine........9 Purpose............2 Operation tips..........9 Overview............ 2 Cutting tips ..........9 Important safety instructions..2 Line cut-off blade........10 Symbols on the machine.... 4 Adjust the length of the cutting line..10 Risk levels........5 Maintenance.......10 Service..........5...
English Brush cutter guard DESCRIPTION Brush cutter blade PURPOSE IMPORTANT SAFETY INSTRUCTIONS This machine is used to cut grass, light weeds, and other similar vegetation at or around ground level. The READ ALL INSTRUCTIONS BEFORE USING (THIS cutting plane must be approximately parallel to the POWER TOOL) ground surface.
Page 6
English • Stay alert – Watch what you are doing. Use of any other battery packs may create a risk of injury common sense. Do not operate this unit when you and fire. Use only Greenworks 82BD400 battery or are tired, ill or under the influence of alcohol, drugs other Greenworks Commercial 82V batteries.
English than recommended by the manufacturer and line proper control until the blade has completely materials of other types – for example, metal wire, stopped rotating. rope, and the like. SAVE THESE INSTRUCTIONS • Danger – Be aware of blade thrust : SYMBOLS ON THE MACHINE •...
English WARNING RISK LEVELS If the battery pack cracks or breaks, with or without The following signal words and meanings are intended leaks, do not recharge it and do not use. Discard it to explain the levels of risk associated with this product. and replace with a new battery pack.
English WARNING For your personal safety, do not insert battery before the tool is assembled completely. ATTACH THE GUARD WARNING Do not touch the cut-off blade. 1. Remove the screws from the trimmer head with the supplied hex wrench. 2. Put the guard onto the trimmer head. 3.
English 4. Squeeze the hooks to open the quick-release fastener. 5. Pull the ends of the straps down to tighten the harness. PUT ON THE BACKPACK 6. Lift the tabs of the adjusters to loosen the straps. 1. The backplate is fastened to the hip belt through the pocket in the back.
English NOTE If you do not use the machine for more than 120 s, the machine will stop. Lights off: the electrical circuit is off (OFF). IMPORTANT Do not keep your finger on the button when you move the machine to prevent accidental start. REVERSE BUTTON 1.
English • Remove the battery pack. • Remove the grass. STOP THE MACHINE 1. Release the trigger. 2. Push the on/off button again to turn the machine off. OPERATION TIPS WARNING Keep clearance between the body and the machine. WARNING Do not operate the machine without guard in place.
English • Wire and picket fences cause cutting line wear and MAINTENANCE breakage. Stone and brick walls, curbs, and wood can wear the cutting line quickly. IMPORTANT Read and understand the safety regulations and the maintenance instructions before you clean, repair or do the maintenance work on the machine.
English 1. Push the tabs on the sides of the trimmer head at the same time. INSTALL THE CUTTING LINE NOTE Do not put more than 26-ft of .095" line at a time. 1. Remove the remaining cutting line on the spool. 2.
English 5. Turn the spool cap clockwise to wind the cutting line into the trimmer head. Keep approximately 5 in of cutting line above out of each side of the trimmer head. REMOVE THE GUARD 4. Put the metal rod (1) in the motor housing hole (2) to 1.
English 3. Tighten the screws with the supplied hex wrench. ASSEMBLE THE BRUSH CUTTER ASSEMBLE THE TRIMMER HEAD WARNING 1. Put the trimmer head onto the housing. Wear gloves and be careful with sharp edges. 2. Install the nut. WARNING 3.
English TROUBLESHOOTING Problem Possible Cause Solution The ma- No electrical 1. Remove battery chine does contact between pack. not start the machine and 2. Check contact and when the the battery pack. install the battery pack trigger is again. pushed. The battery pack Charge the battery is depleted.
English Problem Possible Cause Solution Battery model 82BD400 and other Greenworks Commmer- The battery pack Charge the battery cial 82V batteries is depleted. pack. Charger model 82DPC8A and other The line Lines are welded Lubricate with silicone Greenworks Commercial does not to themselves.
Page 19
English 2-YEAR LIMITED BATTERY WARRANTY COVERAGE: – Greenworks Commercial Battery Packs (82BD250, 82BD400, 82BD500, 82BD800 and other 82BD or GL series) – 2 year from the date of purchase (non transferable) 60-DAY LIMITED WEARABLE PARTS WARRANTY COVERAGE: – Bars – Blades –...
Need help?
Do you have a question about the Greenworks Commercial STB414 and is the answer not in the manual?
Questions and answers