The following instruc�ons will assist you in assembling your par�cular fountain. Depending on which fountain you purchased,
there will be slight varia�ons in the assembly process.
Felicity with Tealights – Item # 03823
Fig. A
Step 1. Set the "Flow Control" on the pump to the fully opened posi�on. Do this by sliding the stem on the front of the pump cover all
+
"
"
the way over to the
sign. (see Fig. A)
Step 2. Insert the included plas�c fi�ng into the outlet of the pump. Some models may already have the fi�ng pre-installed. (see Fig. A)
Step 3. Turn the fountain upside down and atach the pump & fi�ng to the so� tubing extending down from the inside of the fountain.
(see Fig. B and Fig. C)
Step 4. Place the fountain with the atached pump onto the basin. Be sure to check that the basin is si�ng on a level surface.
Step 5. Slowly fill the basin with water un�l it reaches the base of the fountain.
Step 6. Add the included decora�ve rocks (dependent on model) to the top surface of the fountain base.
Step 7. Slide the switch located on the rear side of Tealights to the "ON" posi�on and place in each of the (2) holders on the base of the
fountain.
Step 8. Plug into outlet. Be sure to leave a "Drip Loop" in the wire (see Fig. 1)
Setup hints:
1) If water does not flow shortly a�er power up, unplug and refer to STEP 1 to confirm that the flow control is in the fully open posi�on.
OR Air may be trapped within the pump. Remedy this by removing the pump from the water & placing back into the filled basin.
2) If splashing occurs when the fountain is running, try re-arranging the rocks or reduce the flow rate on the pump by sliding the stem on
the front cover towards the other side.
Assembly Instruc�ons
Mantra with Tealights – Item # 03851
Fig. B
Fountain Base
Tubing
Fig. C Pump installed onto Tubing
Need help?
Do you have a question about the Felicity with Tealights 03823 and is the answer not in the manual?
Questions and answers