Buckingham COMFORTLITE BUCK Assembling Manual

ASSEMBLING THE COMFORTLITE™ CUFF TO STRAP AND PAD ASSEMBLY
1. If the strap is wrapped around the pad detach the hook from the loop and open up the assembly and lay it on a flat surface with the pad side down.
2. Both the cuff and pad are marked left and right. Slide the right side cuff between the
padding and strap of the right side pad so that the inside of the cuff is centered with the
padding.
3. Firmly press the two sections together so that the hook of the cuff completely adheres to
the loop on the back of the padding. Once attached the cuff should not be easily separated
from the pad section.
4. Repeat for the left side cuff and wrap pad strap.
Optional steps if using PN 6911 BuckGuard Retractable Gaff Guard:
1. Disconnect the hook of the
1" BuckGuard retaining strap
from the loop of the wrap
pad strap.
ComfortLite_Pad_Guide.docx (Original Date: 9/8/2023) Rev. (6/17/24)
PN 235555
2. Align the retracting device so that the ¾" web attachment strap on the back of the BuckGuard is facing down.
3. Insert the 1" BuckGuard retaining strap through the opening of the retracting device ¾" web attachment strap.
4. Secure the hook
fastener of the
1" BuckGuard
retaining strap to
the loop fastener
of the wrap pad
strap.
5. The 1" loop fastener
securement piece of
the BuckGuard should
be facing outward and
will adhere to the hook
fastener of the wrap pad
strap when the pad is
wrapped.
WATCH THE
VIDEO HERE