At the end of its useful life it should not be have combined the best features of the disposed of with general waste, it should Duo-Scan with the latest state of the art be taken to a recycling point for electrical/ technology. The result is the new Duo-Scan, electronic equipment.
Higher charge rates from unsuitable chargers may lead to hazards from fire or Although the Duo-Scan runs from a low voltage source, dangerous voltages are generated within the battery leakage in addition to reducing unit. For this reason, no attempt should be made to disassemble the scanner. Should you require any battery life.
Rotate the probe connector until the Before connecting or disconnecting the notches on the probe and scanner align, probe, ensure that the Duo-Scan power is and then screw the retaining ring clockwise switched off and that the probe connector to lock the connector in position.
1. Operating instructions 1.3 Imaging display device connection The Duo-Scan accessories allow the Make sure the connector is correctly ultrasound image to be viewed on the oriented before pushing home and display headset or monitor options. the external threaded metal lock ring...
Page 7
3.5MHz, Foetal Ageing Circles Off 1.4.2 Foetal ageing modes Trunk diameter is the measurement across The Duo-Scan comes with 4 preset modes the embryo body. To use this measurement for foetal aging which help to identify the look at the circles at the bottom of the approximate foetal age.
Page 8
Mode 1: Range or depth of scanning 16 cm Mode 3: Range or depth of scanning 19 cm 1. Operating instructions Mode 1: Range or depth of scanning 16 cm Mode 3: Range or depth of scanning 19 cm RANGE 16 CM RANGE 19 CM...
Page 9
To adjust the Gain or Power values, use the Up and Down keys on the front panel • 1.4.4 Freeze image To freeze the image, press the power button briefly. Pressing this button briefly once more returns the scanner to live imaging • www.imv-imaging.co.uk | 9...
Service Engineers will be available to provide assistance to ensure optimum performance rapid service support and ensure optimum of IMV imaging systems. However there is no performance of your IMV imaging system. substitute for careful usage. The Duo-Scan is designed to be robust,...
• While battery is in good condition and is fully charged, it will run the Duo-Scan for approximately 5 hours. Electrical connection to the battery is Warning: through the latches on either side of the The battery unit must not battery.
To ensure optimum performance we Note: recommend that the equipment is If using soap and water on serviced once a year by a IMV imaging the front panel ensure that no Service Engineer. The Service Engineer will water enters any of the connectors.
Service centres If your Duo-Scan requires servicing, please contact an official authorised service centre or the distributor in your country. • United Kingdom HQ Ireland North America IMV imaging IMV imaging IMV imaging Imaging House Unit 2, Block 3 2900 43rd Street NW...
Need help?
Do you have a question about the Duo-Scan and is the answer not in the manual?
Questions and answers