0. Rescue Sheet Airbag Stored gas Seat belt SRS control unit Gas strut/ inflator pretensioner Preloaded spring High strength Zone requiring Battery low High voltage High voltage special attention voltage battery pack power cable zone component Cable Cut Location...
Lack of engine noise does not mean vehicle is off: vehicle movement capability exists until vehicle is fully shut down. Always wear appropriate PPE. Emblems and Badging The Cadillac Crest appears on the front grille area and the rear liftgate. High Voltage Battery Information...
2. Immobilization / stabilization / lifting IMMOBILIZE VEHICLE • Block the wheels. • Follow procedures for conventional vehicles. Electric Parking Brake (EPB) Applying the Electric Parking Brake Press the EPB switch momentarily. The red parking brake status light will flash and then stay on once the EPB is fully applied. Releasing the Electric Parking Brake Turn the vehicle on.
3. Disable direct hazards / safety regulations Thermal Runaway Mitigation The vehicle is equipped with a battery management system with internal fault detection, including thermal runaway mitigation. In the event of a “Battery Danger Detected” notification, DO NOT disable the 12v battery. Automatic safety systems are enabled when low voltage power is available.
Page 7
Inside Access to Hood Release Power Operation To open the hood, press the button on the instrument panel to the left of the steering wheel. To close the hood, press the button and hold until the hood closes. Manual Operation The Manual Release Cable is located in the driver’s footwell.
VEHICLE AT CHARGE STATION: If able, terminate charging by removing the charge handle from the vehicle. If enabled, the vehicle’s anti-theft alarm may activate. If the charge handle will not release, a manual release loop is located underhood, under an access cover near the left wiper arm.
Page 9
Opening a Locked Door from Inside If the doors remain locked, pull twice on the inside door handle to gain access to the occupant at each seating location. NOTE: An alternative method for rear passenger access may be necessary if the rear door child safety locks are engaged. Steering Column Tilt and Telescoping Control Switch •...
High Strength Steel Content The vehicle structure is made of aluminum. The door reinforcement beams are made of high strength steel. As with any occupant extrication, exercise caution. The vehicle’s high voltage cables and components may be energized with high voltage. Avoid touching or cutting high voltage cables or components during any rescue operation.
6. In case of fire High Voltage Warning, potential for electric shock A battery on fire will not explode A battery on fire will not explode. If battery cells reach high enough temperature, they vent and release electrolyte. Battery electrolyte is flammable. Gases emitted from the battery pack are toxic Skin contact may cause irritation.
8. Towing / transportation / storage Tow Hooks Carefully open the cover in the fascia by using the small notch that conceals the tow eye socket. Install the tow eye into the socket and turn it until it is fully tightened. When the tow eye is removed, reinstall the cover with the notch in the original position.
10. Explanation of pictograms used Electric Vehicle General warning sign Warning, Electricity Battery Technology Lifting Points Thermal Imaging Camera Flammable Toxic Corrosive Injury Risk Use Water Front Compartment Release Power Button Cable Cut Location...
Need help?
Do you have a question about the Celestiq 2025 and is the answer not in the manual?
Questions and answers