Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Casambi VLINCA VBA-RCS4
- Page 1 VBA-RCS4 Version V2.0...
-
Page 2: Product Description
VBA-RCS4 operation manual Product description The VBA-RCS4 is a knob remote controller for CASAMBI lighting network. the main functions include: _ Control other CASAMBI ecosystem devices. _ Control VLINCA VBD (driver) and VBU (bridge) devices. _ Rotary for dimming up(clockwise) and down(counter-clockwise). - Page 3 VBA-RCS4 operation manual Panel structure introduction _ The preset button from 1 to 4 can be configured for Individual luminaire, scenes, groups, or all luminaires control. _ Dim up or dim down the device by the Dim up/down knob rotary clockwise or counter-clockwise.
-
Page 4: Led Indications
VBA-RCS4 operation manual LED indications On LED indicator: Red: when charging. Off: no operation in 3 seconds. Green: when charging complete. Yellow flash fast: in operation – Battery low. Blue flash per 1 second: when it is in pairing mode. On preset button: Off: no operation in 3 seconds. - Page 5 VBA-RCS4 operation manual Charge guide When the device is low battery, charging it timely. Charging it by 5V charger with Type-C interface. Type-C interface.
-
Page 6: Installation
VBA-RCS4 operation manual Installation The knob remote controller can be mounted on the base (which is an optional accessory), buy on demand. - Page 7 VBA-RCS4 operation manual Pair VBA-RCS4 1 Set the device in “pairing mode” With a needle, press and hold the button in the small hole at the back of the device as Picture 1 for 3 seconds then release, the led indicator will flash, it indicates the device is in “Pairing mode”.
- Page 8 VBA-RCS4 operation manual 2 Pair the device into network Long press on the VBA-RCS4 icon. If it is unpaired, add it to network (as in Picture ④ ② ① ③ Picture 2 If it is paired in this APP but other network, click “Unpair device” in the app, then unpaired success (as in Picture ②...
- Page 9 VBA-RCS4 operation manual If it is paired by the other APP device, click “Unpair device”→”Start” in the app. When the progress bar appears, press and hold the button in the small hole at the back of the device as figure 1 once, then unpaired success (as in Picture ①...
- Page 10 VBA-RCS4 operation manual Add the device to the desired network (Evolution Only). The device will now be visible in the Switches tab (as in Picture Picture 5 3 Set the device quit from “pairing mode” After paired, press and hold the small hole as figure 1 again for another 3 seconds, the led indicator will be off and the device quit from “Pairing mode”...
- Page 11 VBA-RCS4 operation manual Configure VBA-RCS4 Select the push buttons of VBA-RCS4 to configure. Configure the button to control a luminaire, a group, scene, or all luminaires (as in Picture ① ② ④ ③ ⑥ ⑦ ⑤ Picture 6...
- Page 12 VBA-RCS4 operation manual Warning The product has a built-in lithium battery, please use it with caution. _ Do not Over-discharging it. Over-discharging will damage the battery life. _ Please charge the device with a matched charger, a mismatched charger may cause abnormal charging speed or damage the battery life.
Need help?
Do you have a question about the VLINCA VBA-RCS4 and is the answer not in the manual?
Questions and answers