Outdoor GreatRoom Company Glass Guard-12-R Assembly Instructions

Round Glass Guard
Assembly instructions for Glass Guard-12-R, Glass Guard-20-R
Included in this Kit

4 Glass Panels

4 Top Clips

4 Bottom Clips
1.
Lay out glass panels onto soft, non-
abrasive surface.
NOTE: Glass Guard should be assembled upside down, and flipped over after assembly.
3.
Assemble bottom clips onto glass by aligning the open slots in the clips over the glass and pressing firmly
down. Flip glass guard over after all four bottom brackets have been assembled. Position glass guard on
your fire table, centered on the burner.
WARNING: ALLOW GLASS TO COOL BEFORE TOUCHING. IF PICKING UP THE GLASS GUARD TO MOVE FOR ANY REASON, GRIP
THE MIDDLE OF TWO OPPOSITE GLASS PANELS AND APPLY CONSTANT PRESSURE TOWARDS THE INSIDE OF THE GLASS GUARD.
HOT GLASS WILL CAUSE
BURNS
DO NOT TOUCH GLASS
UNTIL COOLED
NEVER ALLOW CHILDREN
TO TOUCH GLASS
Top Clips
Bottom Clips
2.
Begin assembling TOP CLIPS onto the glass. Insert glass
into slot in the clip by starting at an angle and rotating
down as shown below.

Keep children away.

CAREFULLY SUPERVISE children near fire pit.

Alert children and adults to hazards of high
temperatures.

High Temperatures may ignite clothing or other
flammable materials.

Clothing, furniture and other flammable
materials must not be placed on or near the glass
guard.

Do not leave appliance unattended while
What Is Needed

Soft leather gloves for handling glass panel

Soft non-abrasive surface for assembly
Top Clips
42501A1.22.19