Page 4
This “assembly manual” for KUMO awnings has been produced by SHADELAB to supply the indications necessary for the operations of assembling the components that make up the product. Assembly must be carried out by personnel with suitable technical and professional qualifications, in accordance with the respective national laws or regulations (see Par.
Page 5
To ensure the correct assembly of the mechanical part, of the textile part, and consequently the optimum operation of the finished product, it is necessary to be in possession of the following equipment: »» fabric rolling frame; »» assembly frame with arms and vertically movable positioning bar; »»...
Page 6
IMPORTANT SHADELAB guarantees the EC marking only for products supplied by the company itself. If any parts have to be replaced with other components not guaranteed by SHADELAB, the product guarantee will automatically become void and SHADELAB shall not answer for any malfunctions of the product.
Page 7
Awning dimensions with arms folded Wall installation Awning dimensions with arms folded Roof installation Arm lenght and inclination...
Page 9
Brackets position for Kumo on the wall Define the distance of the brackets and position them on the awning assembly frame. L is the width of the awning. Use anchors M10, or at most M12. Brackets position for Kumo on the ceiling Define the distance of the brackets and position them on the awning assembly frame.
Page 10
Kumo for ceiling ATTENTION: For roof-mounted awnings, the support must be fitted vertically, and the square nut inserted in the slot at the top. Kumo for wall Install the awning on the brackets fixed to the wall.
Page 11
Detail of fixing screws/brackets ATTENTION: Block the awning with the screws Regulating the awning ATTENTION: Ensure that there are no persons, animals or things in the vicinity while opening/closing the awning.Open the awning.
Page 12
Inclination adjustment ATTENTION: Regulating the awning: slacken the side screw (see ref. 1), (Allen wrench 10). To increase the inclination, slacken the socket-head screw (Allen wrench 6) (see ref. 2). To decrease the inclination, tighten the socket-head screw, raising the terminal bar. After regulation, check that the terminal bar is perfectly horizontal.
Need help?
Do you have a question about the KUMO and is the answer not in the manual?
Questions and answers