enphase ClipperCreek CP-50 User Manual
  1. Manuals
  2. Brands
  3. enphase Manuals
  4. Test Equipment
  5. ClipperCreek CP-50
  6. User manual
enphase ClipperCreek CP-50 User Manual

enphase ClipperCreek CP-50 User Manual

Hide thumbs

Advertisement

Table of Contents

A division of Enphase Energy, Inc.
User Manual
• • • • • • •
CP-50

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ClipperCreek CP-50 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for enphase ClipperCreek CP-50

  • Page 1 A division of Enphase Energy, Inc. User Manual • • • • • • • CP-50...
  • Page 2 CP-50 User Manual PLEASE NOTE This user manual includes the latest information at the time of printing. Enphase Energy, Inc. reserves the right to make changes this product by other than an authorized service facility may void the product warranty.

  • Page 3: Table Of Contents

    CP-50 User Manual CONTENTS OVERVIEW ................5 VERIFY VEHICLE CHARGE REQUEST RESPONSE ..6 PROXIMITY SIGNAL TEST ..........6 LINE 1, LINE 2/N EVSE OUTPUT TEST......7 PILOT COMMUNICATION SIGNAL TEST ......7 CCID TRIP POINT ..............9 RESET THE EVSE..............9 CUSTOMER SUPPORT ............10 WARRANTY INFORMATION ..........11...
  • Page 4 CP-50 User Manual ILLUSTRATIONS Figures 1. The CP-50 ................5 2. Connector in CP-50..............6 3. Pilot Signal State B, Charge Not Requested ......8 4. Pilot Signal State C, Charge Requested .........8 5. CCID Trip Point ..............9...

  • Page 5: Overview

    CP-50 User Manual OVERVIEW The CP-50 is an optional piece of test equipment which can be without an electric vehicle present. The primary purpose of the and that the EVSE properly responds to a ground fault condition. The installer may test the EVSE charge request response with the CP-50 tester alone.

  • Page 6: Verify Vehicle Charge Request Response

    CP-50 User Manual VERIFY VEHICLE CHARGE REQUEST RESPONSE light will be lit on the EVSE. On Side B of the CP-50, verify that Figure 1. Plug the EVSE See Figure 2. No lights on the CP-50 will be illuminated when a charge is not requested.

  • Page 7: Line 1, Line 2/N Evse Output Test

    CP-50 User Manual LINE 1, LINE 2/N EVSE OUTPUT TEST WARNING: voltage is present at these testpoints. It is suggested that the following steps be performed in the order shown below. Plug the EVSE testpoints located on Side A of the CP-50. See Figure 1. The DVM should read less than 15VAC.
  • Page 8 CP-50 User Manual Figure 3: Pilot Signal State B, Charge Not Requested The red light will illuminate to indicate that power is applied to the CP-50 tester and the EVSE will also indicate a charge in progress. Use an oscilloscope to verify the Pilot communication square wave signal.

  • Page 9: Ccid Trip Point

    CP-50 User Manual CCID TRIP POINT simulate a ground fault by Fault or Protection light on an EVSE will illuminate to indicate a fault. Figure 5 illuminates on a ClipperCreek EVSE when the CCID TRIP button when indicating a fault. Figure 5: CCID Trip Point CCID TRIP Button...

Table of Contents