Page 1
Model Number Serial Number Date of Purchase Part Description and number as shown in parts list Piper Products, Inc. 300 South 84 Avenue Wausau, WI 54401 Phone: 715-842-2724 / Fax 715-842-3125...
Service is available through Authorized Piper Products Parts and Service Distributors throughout the United States. For a complete listing of these call or write Piper Products, Inc. for the name of the nearest distributor. This equipment is intended for commercial use only. Not for household use.
9/3/2015 INSTALLATION ELECTRICAL CONNECTION WARNING!!!! DO NOT USE EXTENSION CORDS (VOIDS WARRANTY) Ground: The electrical outlet must be provided with an efficient ground, and the voltage and the frequency of the electrical line matches those indicated on the data plate. If unsure about the efficiency of the ground, have your electrical circuit checked by a qualified technician Supply Voltage :...
9/3/2015 START-UP AND OPERATION OPERATING THE COOLER Before Operating the Cooler Ensure that the electrical outlet is connected effectively to earth (ground), suitable to provide the voltage indicated on the data plate. Ensure proper air flow to the front rear and sides. ...
9/3/2015 THERMOSTAT SETTINGS TEMPERATURE CONTROL: Setting: (Factory set) Temperature control is set at 25°F with a 12 degree differential. Defrost: D efrost is not installed in this unit and needs to be turned off after service. Changes in the Settings: Adjustments to the settings may be needed but shouldn’t be set below 13°F for temperature with a 12 degree differential.
9/3/2015 MAINTENANCE To obtain the best performance from your equipment, it should be cleaned daily and maintained in good condition. SAFETY / ENVIRONMENTAL CAUTION PERSONAL PROTECTION Check your company safety and environmental policy before cleaning or servicing. Safety Tip! : Utilize protective gloves and safety glasses ELECTRICAL POWER: Before performing EXTENDED CLEANING where electrical components can become wetted, the power switch must be turned to OFF and the unit...
9/3/2015 STAINLESS STEEL AND GENERAL CLEANING Stainless Steel and Aluminum: Piper only approves soap and water for cleaning stainless steel. NOTICE: Do NOT use chlorinated cleaners. General Surfaces, Fiberglass: Clean surfaces with a soft cloth or sponge utilizing a mild detergent. Rinse completely with warm water and then dry.
Remove pan covers for proper air flow. Thermostat Control Is the thermostat control set properly? Voltage Call a service technician. CM & CI units need to be used with ice to meet NSF classification. Call Piper Products directly at 800-544-3057 if you need further assistance. For Tech Support, call 800‐544‐3057, Fax 715‐842‐3125 www.piperonline.net...
9/3/2015 PIPER PRODUCTS, INC. LIMITED WARRANTY Piper Products, Inc. warrants to the original purchaser that its equipment will be free from defects in the materials and/or parts for a period of 12 months from date of shipment and reported to the factory. The purchaser is responsible for having equipment properly installed, operated under normal conditions with proper supervision and to perform periodic preventative maintenance. Equipment failures caused by inadequate water quality, improper cleaning, harsh chemicals, or acids are not covered under warranty. The manufacturer’s obligation under this warranty shall be the replacement or repair of defective parts within the warranty period. Excessive labor (more than 1/2 hour) required to access Piper equipment built into cabi‐ nets, tables or structures by others, is NOT covered under labor warranty. Example: Piper multiple‐ or single‐ well food wells. All labor shall be performed during regular working hours. Overtime premium will be charged to buyer. After thorough examination, the decision of the Piper Products Service Department shall be final. Any defective parts to be repaired or replaced must be returned to Piper Products, Inc., 300 South 84th Avenue, Wausau, WI 54401, transportation charges prepaid, and they must be properly packed and tagged. The serial and model number of the equipment and date of original installation of such equipment must be given.
Need help?
Do you have a question about the 2-CI and is the answer not in the manual?
Questions and answers