Welcome to AEG! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. INSTALLATION....................6 4. CONTROL PANEL..................9 5.
Page 3
of age should be kept away from the appliance unless continuously supervised. • Children should be supervised to ensure that they do not play with the appliance. • Children shall not carry out cleaning and user maintenance of the appliance without supervision. •...
• When the appliance is empty for long period, switch it off, defrost, clean, dry and leave the door open to prevent mould from developing within the appliance. • Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. •...
Page 5
2.4 Care and cleaning • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. WARNING! 2.3 Use Risk of injury or damage to the appliance. WARNING! • Before maintenance, deactivate the appliance and disconnect the mains plug Risk of injury, burns, electric shock or from the mains socket.
• The refrigerant circuit and the insulation • Do not cause damage to the part of the materials of this appliance are ozone- cooling unit that is near the heat friendly. exchanger. • The insulation foam contains flammable gas. Contact your municipal authority for information on how to discard the appliance correctly.
Page 7
Make sure that air can circulate freely around the back of the cabinet. Overall dimensions ¹ This appliance should be installed in a dry, well ventilated indoor position. This appliance is intended to be used at ambient temperature ranging from 10°C to 43°C.
Page 8
in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. WARNING! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely. 3.4 Ventilation requirements The airflow behind the appliance must be sufficient.
4. CONTROL PANEL Power indicator light A medium setting is generally the most suitable one. Temperature regulator and On/Off switch To operate the appliance: Frostmatic light Frostmatic switch and alarm reset switch 1. Turn the temperature regulator clockwise to obtain a lower temperature inside the Alarm light appliance.
4.5 High temperature alarm When normal conditions are restored the Alarm light and the sound turns off When there is a temperature increase in the automatically. freezer compartment (e.g. due to a power failure) the Alarm light is blinking and sound is on.
Page 11
6.2 Hints for freezing 6.3 Hints for storage of frozen food • Activate Frostmatic function at least 24 • Freezer compartment is the one marked hours before placing the food inside the with freezer compartment. • The medium temperature setting ensures •...
1. Switch off the appliance or pull out 6. Switch on the appliance and close the electrical plug from the wall socket. door. 2. Remove any stored food and put it in a 7. Set the temperature regulator to obtain cool place.
Page 14
Problem Possible cause Solution Many food products were put in at Wait a few hours and then check the the same time. temperature again. The room temperature is too high. Refer to "Installation" chapter. Food products placed in the appli‐ Allow food products to cool to room ance were too warm.
Page 15
Problem Possible cause Solution The thickness of the frost is greater Defrost the appliance. than 4-5 mm. The door has been opened often. Open the door only if necessary. The Frostmatic function is switched Refer to "Frostmatic function" sec‐ tion. There is no cold air circulation in the Make sure that there is cold air cir‐...
9. NOISES SSSRRR! BRRR! CLICK! HISSS! BLUBB! 10. TECHNICAL DATA The technical information is situated in the information related to the performance of the rating plate on the internal side of the appliance. Keep the energy label for appliance and on the energy label. reference together with the user manual and all other documents provided with this The QR code on the energy label supplied...
12. ENVIRONMENTAL CONCERNS appliances marked with the symbol with Recycle materials with the symbol . Put the the household waste. Return the product to packaging in relevant containers to recycle it. your local recycling facility or contact your Help protect the environment and human municipal office.
Need help?
Do you have a question about the OAB6L88ES and is the answer not in the manual?
Questions and answers