Download Print this page

molex MOD STRUT II Installation Instructions

Download this manual

1.0 SCOPE

This document provides the installation instruction for the Mod Strut II - Mounting Kit

2.0 HARDWARES

EC/ECM NO: 108434

SAP EC NO: 10794823

MPN/FMT-042 (2016/07/01 REV-00).

THIS INFORMATION IS CORRECT AS AT THE TIME OF PUBLICATION, SPECIFICATION ARE SUBJECT TO CHANGE

INSTALLATION INSTRUCTIONS

MOD STRUT II – MOUNTING KIT

SAP NO : 187000489

http://www.molexpn.com/

BEFORE INSTALLING OR ADJUSTING THIS PRODUCT,

PLEASE READ THESE INSTRUCTIONS CAREFULLY.

PLEASE KEEP THIS GUIDE FOR FUTURE REFERENCE

Doc No: 187000489 Doc part: AS

REV- A2

DATE: 2016/SEP/27

SHEET No. 1 of 4

Need help?

Do you have a question about the MOD STRUT II and is the answer not in the manual?

Page 1 PLEASE READ THESE INSTRUCTIONS CAREFULLY. PLEASE KEEP THIS GUIDE FOR FUTURE REFERENCE MOD STRUT II – MOUNTING KIT 1.0 SCOPE This document provides the installation instruction for the Mod Strut II - Mounting Kit 2.0 HARDWARES EC/ECM NO: 108434 SAP NO : 187000489...
Page 2 3. INSTALATION PROCEDURE STEP 1 Position rack at desired location and mount to floor (not to exceed 36" (914.4 mm) From wall. STEP 2 Remove the back rail located on the top of the rack. The existing holes will be used when attaching the Mod Strut (Steps 5 &...
Page 3 STEP 3 Measure distance from floor to hole in rack. Drill hole in wall measured equally from floor. STEP 4 Slide Channel "A" onto Channel "B" to required length and lock together using one Lock Washer, Flat Washer, Hex Head Bolt, and Hex Nut for each side. EC/ECM NO: 108434 SAP NO : 187000489 Doc No: 187000489 Doc part: AS...
Page 4 STEP 5 Install assembled Mod Strut II to rack using Hex Head Bolt, Flat Washer, Lock Washer and Hex Nut for each side. STEP 6 Complete installation by attaching the other end of Mod Strut II to the wall using appropriate hardware.