K&M Analog Designs Two-Rack TS-1 Owner's Manual page 4

Rear Panel Functions
A/C Input- Connects the amplifier to A/C power via the power cord supplied. Unless otherwise specified, your amplifier
is designed to operate on 120 volts A/C, 60 cycles.
Fuse- See Fuse Chart
Power Switch- Turns power on.
Operate/Stand-by Switch- Should be in the "down" or "stand-by" position when you apply power to the unit. After a few
seconds, place the switch in the "up" position to use the amplifier. You may leave the unit "powered up" and place this
switch in the "stand-by" position to mute the output.
Speaker Output Jacks- There are 3 speaker output jacks; 4,8, and 16 ohms. NEVER OPERATE YOUR AMPLIFIER
WITHOUT A PROPER SPEAKER LOAD CONNECTED. Be sure to match the impedance of your cabinet with the im-
pedance (output) of the amplifier.
Effects Send- Use this jack to send the amplifiers signal to outboard effects.
Effects Return- Use this jack to connect the output of your effects to the amplifier.
NOTE: This model does not utilize a full (input and output) buffered effects loop. For best results, you will need an Ef-
fects Loop Interface (ELI1 or ELI2) or similar unit.
Lead Channel Switch- Sends the instrument signal through the lead circuit, adding extra stages of gain to the signal and
enabling the lead gain and lead master controls. To enable foot switch control of this function, switch must be in the down
position.
Bypass Switch- This switch bypasses the tone controls, increasing both level and mid-range response. To enable foot-
witch control of this function, switch must be in the down position.
Footswitch Jack- The footswitch connects here. The clean/lead and tone bypass functions can only be activated via the
footswitch.
S/N- Your serial number is located here. We strongly suggest that you record this number and have it handy in case you
need service, or in the event that your amp is lost, stolen, or damaged.
NOTE: All switches are ON in the "up" position