RAB EMHB30 Instructions

INSTRUCTIONS
Emergency Battery Backup Installation
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We'd love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fixtures must be wired in accordance with the National Electrical Code and al applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
PLEASE READ AND FOLLOW ALL SAFETY INSTRUCTIONS
WARNING: AC power must be off before proceeding with assembly or installation of emergency LED driver.
IMPORTANT: An unswitched AC power source of 120VAC to 277VAC is required. This device is designed for use in fixtures listed for dry,
damp and wet locations. Emergency LED driver should be charged for 24 hours every 6 months during storage.
CAUTION:
• Make sure all electrical connections conform to the National Electrical Code and all applicable local regulations.
• Do not let power supply cords touch hot surfaces.
• Do not mount near gas or electric heaters.
• Use with grounded UL Listed dry, damp or wet location rated fixtures.
• The Emergnecy LED Driver is intended for ordinary locations and for permanent installation.
• Battery is rechargeable Li-ion type and must be recycled or disposed of properly.
Do not use this emergency driver with accessory equipment other than recommended by manufacturer; failure to follow this may
cause an unsafe condition. Servicing should only be performed by qualified service personnel. Do not use this emergency driver for
other than intended use.
IMPORTANT: When the LED indicator is illuminated the battery is in charge mode when AC power is applied. It is recommended and
required by applicable code to test emergency LED driver to ensure proper function of the system; test every thirty (30) days to ensure
the emergency driver is functioning by illuminating the light source. Conduct a ninety (90) minute discharge test one (1) time per year;
LED light source should be illuminated for 90 minutes.
TESTING SYSTEM: The emergency battery requires a minimum charge of one (1) hour before testing the circuit. A full charge requires
twenty-four (24) hours.
EMHB30
EMHB60