M&C V3/2-H Instruction Manual

M&C V3/2-H Instruction Manual

Electrically heated ball and solenoid valve

Advertisement

Quick Links

Electrically Heated Ball and Solenoid Valve
Series
V3/2-H, V3/2-H/PE, V3/2-H/EA and
MV3/2-H
Instruction Manual
Version 1.01.00

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the V3/2-H and is the answer not in the manual?

Questions and answers

Summary of Contents for M&C V3/2-H

  • Page 1 Electrically Heated Ball and Solenoid Valve Series V3/2-H, V3/2-H/PE, V3/2-H/EA and MV3/2-H Instruction Manual Version 1.01.00...
  • Page 2 With the release of this version all older manual versions will no longer be valid. The German instruction manual is the original instruction manual. In case of arbitration only the German wording shall be valid and binding. Version: 1.01.00 V3/2-H, MV3/2-H | 1.01.00 www.mc-techgroup.com...
  • Page 3: Table Of Contents

    Figure 4 Electrically heated 3-way ball valve V3/2-H ..........................19 Figure 5 Electrical connections of electrically heated 3-way ball valve V3/2-H/EA with electrical actuator ... 20 Figure 6 Electrically heated 3-way ball valve V3/2-H/EA with electrical actuator ..............21 Figure 7 Electrically heated 3-way ball valve V3/2-H/EA with electrical actuator and position indication ....
  • Page 4: General Information

    The requirement of the EU directive 2014/35/EU “Low Voltage Directive“ are met. The compliance with this EU directive has been examined according to DIN EN 61010. Declaration of conformity The EU Declaration of conformity can be downloaded from the M&C homepage or directly requested from M&C. V3/2-H, MV3/2-H | 1.01.00 www.mc-techgroup.com...
  • Page 5: Safety Instructions

    M&C, please be sure that it is properly packaged and shipped with protective packaging. The repaired or replaced device will be shipped free of delivery charges to the point of use. www.mc-techgroup.com V3/2-H, MV3/2-H | 1.01.00...
  • Page 6: Used Terms And Signal Indications

    Do not breathe vapors; avoid contact with skin and eyes. Hot surface! Contact may cause burn! Do not touch! Wear protective gloves! Working with chemicals, sharp objects or extremely high temperatures re- quires wearing protective gloves. V3/2-H, MV3/2-H | 1.01.00 www.mc-techgroup.com...
  • Page 7 Wear protective clothes! Working with chemicals, sharp objects or extremely high temperatures re- quires wearing protective clothes. Use foot protection Use safety helmet and full protective goggles www.mc-techgroup.com V3/2-H, MV3/2-H | 1.01.00...
  • Page 8: Introduction

    INTRODUCTION The M&C electrically heated 3/2-way ball valves type V3/2-H… as well as the solenoid valve MV3/2-H are used in heated analysis systems to switch between the following functions: • sample gas to the analyzer(s), • calibration gas to the analyzer(s) or •...
  • Page 9: Technical Data

    8 kg [≈ 17.6 lb] Dead volume Approx. 5cm Materials of sample wetted parts Stainless steel 316Ti, PTFE Stainless steel 316Ti, FKM, FFKM Mounting Wall mounting ® is a registered trademark for tube fittings by Swagelok Company, USA. Swagelok www.mc-techgroup.com V3/2-H, MV3/2-H | 1.01.00...
  • Page 10: Applications

    Note PREPARATION AND INSTALLATION Locate the heated 3-way-valves type V3/2-H… and MV3/2-H in such a way that there is adequate space for re- moving the cover and connecting the sample lines. Fix the aluminium plate with 4 screws. Make certain that the heated 3-way-valves are easily accessible so that you can carry out any subsequent mainte- nance work without trouble.
  • Page 11: Mounting

    MOUNTING 1. Loosen the four clamps on top and at the bottom. 2. Remove the cover of the heated 3-way-valve type V3/2-H… and MV3/2-H. 3. Remove the aluminium lid by loosening the two screws. 4. Connect the sample lines to the fittings.
  • Page 12: Preparations For Commissioning

    Warning responds with the information stated on the valves type plate. Switch on mains power supply. The total heating-up time is approximately 30 min. The heated 3-way-valves type V3/2-H… and MV3/2-H are then ready for operation MAINTENANCE No special maintenance necessary.
  • Page 13: Spare Part List

    SPARE PART LIST Wear, tear and replacement part requirements depend on specific operating conditions. The recommended quantities are based on experience and they are not binding. Heated 3-way-valves type V3/2-H… and MV3/2-H (C) Consumable parts (R) Recommended spare parts (S) Spare parts...
  • Page 14: Figure 1 Overview Risk Assessment

    Chemical burns due to aggressive media possible! This applies to all liquids in vessels and in the product. In general, for electrical and mechanical work on the product, wear personal protective equipment (PPE) in accordance with the risk assessment. V3/2-H, MV3/2-H | 1.01.00 www.mc-techgroup.com...
  • Page 15 The product can be transported by 1 to 2 person(s). The instructions for appropriate personal protective equipment (PPE) must be observed. The weight specifications are contained in the technical data of this product. Furthermore, the work safety regulations of the operator must be observed. www.mc-techgroup.com V3/2-H, MV3/2-H | 1.01.00...
  • Page 16: Appendix

    Electrically heated 3-way ball valve V3/2-H/PE with 2 off position switch • Electrically heated 3-way ball valve V3/2-H • Electrical connections of the electrically heated 3-way ball valve V3/2-H/EA with electrical actuator • Electrically heated 3-way ball valve V3/2-H/EA with electrical actuator •...
  • Page 17: Figure 2 Electrically Heated 3-Way Solenoid Valve Mv3/2-H

    Figure 2 Electrically heated 3-way solenoid valve MV3/2-H www.mc-techgroup.com V3/2-H, MV3/2-H | 1.01.00...
  • Page 18: Figure 3 Electrically Heated 3-Way Ball Valve V3/2-H/Pe With 2 Off Position Switch

    Figure 3 Electrically heated 3-way ball valve V3/2-H/PE with 2 off position switch V3/2-H, MV3/2-H | 1.01.00 www.mc-techgroup.com...
  • Page 19: Figure 4 Electrically Heated 3-Way Ball Valve V3/2-H

    Figure 4 Electrically heated 3-way ball valve V3/2-H www.mc-techgroup.com V3/2-H, MV3/2-H | 1.01.00...
  • Page 20: Figure 5 Electrical Connections Of Electrically Heated 3-Way Ball Valve V3/2-H/Ea With Electrical Actuator

    Figure 5 Electrical connections of electrically heated 3-way ball valve V3/2-H/EA with electrical actuator V3/2-H, MV3/2-H | 1.01.00 www.mc-techgroup.com...
  • Page 21: Figure 6 Electrically Heated 3-Way Ball Valve V3/2-H/Ea With Electrical Actuator

    Figure 6 Electrically heated 3-way ball valve V3/2-H/EA with electrical actuator www.mc-techgroup.com V3/2-H, MV3/2-H | 1.01.00...
  • Page 22: Figure 7 Electrically Heated 3-Way Ball Valve V3/2-H/Ea With Electrical Actuator And Position Indication

    Figure 7 Electrically heated 3-way ball valve V3/2-H/EA with electrical actuator and position indication V3/2-H, MV3/2-H | 1.01.00 www.mc-techgroup.com...

This manual is also suitable for:

V3/2-h/peMv3/2-hV3/2-h/ea

Table of Contents