Summary of Contents for Martello Blastrac BS 110
- Page 1 User Guide Blastrac BS 110 Martello Hire & Logistics Limited Unit 12 Riverside Industrial Estate West Hythe Road Hythe Kent CT21 4NB Tel: 01303 901399 P a g e...
- Page 2 Always call Martello Hire with any questions about the safety of the electrical components. • Work on the electrical equipment or operating materials may only be undertaken by Martello Hire. • Pull out the main plug during inspections of the machine.
- Page 3 The following sticker is placed on the machine: Meanings of these symbols are: • Ear protection is obliged • Safety glasses with lateral protection are obliged • CE – mark on this machine • Safety shoes obliged • Consult the manual before operating the machine Personnel must wear gloves, a dust mask and tie back long hair/not wear loose clothing or jewellery including rings when operating the machine.
- Page 4 • Line up the wheen hub hole to insert pins. • Lay the machine all the way back on the steering handle (Pic. 1). • Rotate wheel to align holes (Pic. 2) • Insert the quick relese pin (Pic. 3) •...
- Page 5 Operation Electric Controls The selection switch (1) is mounted on top of the machine. Switch to 1 to activate the frequency driver and the machine is ready to drive with drive motor. The drive speed can be adjusted with the drive speed control (2). The right switch, lever (3) is to drive the motor to forward and the left switch lever (4) is to the drive motor backward.
- Page 6 • Wear cut resistant gloves • Ensure plug is removed from power supply • Place a block under the front of the machine • Loosen the 5 bolts • Remove existing blade if there is one • Replace with a sharp blade •...
- Page 7 Ceramic (glued with double duty or mud sets): Before removing ceramic tile, tiles will have to be pre-broke with a mallet or larger hammer. On small random block styles of tile, pre-breaking may not be necessary. Open an area large enough for the machine or blade to fit in or start from a doorway. Keep work area clean to keep good wheel contact with the floor.
- Page 8 Checker-Board Ditching: • To make carpet removal and clean up easier • Use a wide self-scoring blade across the floor • Remove remaining flooring in the opposite direction, this will create smaller pieces of debris that are easier to dispose of. •...
Need help?
Do you have a question about the Blastrac BS 110 and is the answer not in the manual?
Questions and answers