Summary of Contents for Etnyre RoadSaver II
- Page 1 RoadSaver II Smart OPS Automatic/1 Button system Troubleshooting Guide Etnyre International www.etnyre.com 1333 S. Daysville Road, Oregon, IL 61061 USA Ph: (815) 732-2116...
-
Page 2: Cautions And Warnings
Always shut off the vehicle engine and disconnect pump electrical power before working on the hydraulic system. Etnyre International is not responsible or liable for injury, damage, or loss caused by improp- er installation by the end user, misuse of the equipment, lack of maintenance, accidents, or failure to follow instructions. - Page 3 1 Button Troubleshooting Guide Section No. 10, 1 button wiri ng RoadSaver II Smart OPS Automatic/1 Button system 1. Identity the Smart Ops controller from the CAN controller. The controller clos- figure 10-1 est to the bulkhead is the Smart OPS controller.
- Page 4 1 Button Troubleshooting Guide RoadSaver II Section No. 10, 1 butt on wiri ng Smart OPS Automatic/1 Button system figure 10-5 7. Remove both wires from pins 15 and 16 from the black 50 pin connector. 8. Locate the wire that is to be removed.
- Page 5 1 Button Troubleshooting Guide RoadSaver II Section No. 10, 1 butt on wiri ng Smart OPS Automatic/1 Button system 14. With both wires removed from pins 15 and 16 connect each to a 12volt multi meter to evaluate signal. figure 10-10 15.
-
Page 6: Parts Order Form
1 Button Troubleshooting Guide RoadSaver II PARTS ORDER FORM BILL TO: SHIP TO: Company: Company: Name: Name: Address: Address: Phone: Phone: FAX: FAX: Page # Ref # Description Preferred Shipping Method: Send Order To: Etnyre International 3650 N Sabin Brown Rd...
Need help?
Do you have a question about the RoadSaver II and is the answer not in the manual?
Questions and answers