Ultrawave Sanitiser Series Quick Manual

Sanitiser Quick Guide
Please download the full manual from the Ultrawave website
https://ultrawave.co.uk/ultrawave-downloads/
Electrical Safety instructions
The Ultrawave Sanitiser bath is designed to be connected to a 230V 50Hz
electrical supply via a three-pin plug.
Always connect to a fully earthed supply using the moulded plugs provided. It
can be dangerous to operate an ultrasonic bath without an earth connection.
The unit is supplied with a removeable power lead rated at 5A. Do not use a
power lead rated less than 5A.
The removeable power lead is the disconnect device and should remain
accessible while the unit is in use.
The IEC C14 electrical socket on the rear of the unit is fitted with 2x T5A
(slow blow) fuses. Never fit a fuse of a higher rating.
The unit is rated at up to 500W.
Ensure that any excess power cable is stored neatly.
Using this machine in a manner not specified by Ultrawave may lead to
damage or electrical safety impairment.
Ultrawave will not be responsible for damage or injury caused by incorrect
use of the equipment.
General Safety Instructions
Ensure that the bath contains liquid before you switch it on.
Always use a basket to support items to be cleaned.
Not doing so may damage the bath and invalidate your warranty.
Do not place hands or fingers in the bath when it is operating.
Care should be taken when operating the bath at higher temperatures as
external surfaces may become hot.
Never use toxic, flammable, acidic, caustic or corrosive solutions in the bath.
Do not move the bath when it contains water.
Before cleaning, drain the bath. Clean by wiping with a clean non-abrasive
cloth.
The user should familiarise themselves with the full instruction manual before
operating the equipment and should apply to Ultrawave or its agent for
advice on cleaning techniques or detergents. Ultrawave will not be
responsible for damage or injury caused by incorrect use of the equipment.
Sanitiser quick guide C6055201-03 (Jul22)