Prima DTA-1496 User Manual page 7

Channel setup:
By pressing MENU button ,and then pressing VOL-/+ button it will bring you to
Channel Setup menu. You will see the following display on TV screen.
Follow the procedure below to select above options:
1.Press the CH(+) and CH(-) button to go up and down the menu.
2.Press VOL (+) button or VOL (-) button to select your preference.
Channel System: Press the VOL(-/+) buttons to select the correct channel system.
Air Cable:
Skip :
Current Ch. :
Fine:
Auto Program:
Note: The Auto Search function will scan the channels on the selected antenna
input. If the TV is connected to cable, please select Cable under
Channel
Channel System
Air Cable
Skip
Current Ch.
Fine
Auto Program
In general, you can set it as "AUTO" AUTO,NTSC and NTSC443
will display in turn
Press VOL (+) button or VOL(-) button to select
(VHF and UHF) or Cable Antenna (CATV) reception preference.
Press VOL(+) button or VOL(-) button to add or delete a channel
from the stored memory.
Press VOL(+) button to go up and VOL (-) button to go down to set
the channel position. The display will show the current playing
channel.
Channel Coverage by Antenna:
Antenna Type
VHF
UHF
CATV
If the picture and/or sound are poor, try using the FINE TUNE
feature. Do not use this feature unless reception is poor. Press
VOL (+/-) to start the Fine Tune function.
Press VOL (+) button to auto program channels. This search
automatically adds only the active channels in your area to the TV's
memory. It deletes any channels on which there is no broadcast or
a poor signal.
Auto
Air
off
2
Channel Range
2-13
14-69
1-125
Aerial Antenna
' Air Cable ' sub menu.