Advertisement
Quick Links
Soft Close Toilet Seat
Fittings
Installation Steps
Before installation check that all parts are present.
9
6
6.To remove the seat press the quick
release button and lift off.
10
10.To remove the seat press the quick
release button and lift off.
Installation Instructions
3.Do not fully tighten.
7.Fully tighten the fixings.
11
4
4.Line the mounting posts up with
the holes in the hinge section of the
seat and click into place.
B
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Britton TRCCWC
- Page 1 Installation Instructions Soft Close Toilet Seat Fittings Installation Steps Before installation check that all parts are present. 3.Do not fully tighten. 4.Line the mounting posts up with the holes in the hinge section of the seat and click into place. 7.Fully tighten the fixings.
-
Page 2: Installation Instructions
Installation Instructions Operation Allow the seat and lid to close under their own weight. Care and Maintenance Do not stand on the seat or lid as this can cause damage. As with all toilets seats: If you use bleaches and strong cleaners in the pan, do not leave the seat closed whilst the cleaner acts on the pan–... - Page 3 SP697 SP1220-1 SP1375-1 Installation Instruction for Dual Flush Cistern Fittings Parts Supplied: Flush Cone Inlet Valve Flush Valve Button Bolt SP697 SP1375-1 SP1220-1 ● Please read these instructions carefully to avoid damage to the valves, and to ensure correct installation. ●...
- Page 4 To increase the water level: To decrease the water level: Hold the water inlet body, use a screw driver to adjust the Hold the water inlet body, use a screw driver to adjust the Adjustment Rod clockwise (as shown). Adjustment Rod anti-clockwise (as shown). The float should be raised.
- Page 5 Flush Valve Installation And Problem Solving 1: Flush Valve scale and adjustment setting Note: The Flush Valve should be adjusted for the particular cistern into which it is being installed. Please refer to the Adjustment Instruction on page 6 for the full flush and half flush settings. The diagrams below show the detailed adjustment method.
- Page 6 Cistern and Flush Button Installation 1: Install Close Coupled Cistern To Pan 2: Connect the water supply to the cistern * Please ensure the flush cone is in position before installation. A thin bead of silicone should be applied to the flush cone and the inlet hole of pan if necessary. 3: Install The Flush Button Full flush Half Flush Button - Blue...
- Page 7 Inlet Valve Adjustment Instructions Note: The above diagram is for reference only. The inlet valve can be adjusted to suit the particular cistern, please refer to below tables for the settings. For adjustment method, please refer to the installation instruction on page 1 & 2. L (mm) L (mm) Range...
- Page 8 Flush Valve Adjustment Instructions Note: The above diagram is for reference only. In this example, A is set to 6.5 and B is set to 2. The flush valve can be adjusted to suit the particular cistern, please refer to below tables for the settings.
- Page 9 Recommended length of push rods Push rod The push rods can be cut off to suit the particular cistern, please refer to below table for the Z value. Range Cistern code Z (mm) 15.B.27349 Stadium 15.B.27353 Sphere MAR.0006 Milan ZEN.002 Trim TRIM.002 SHR.045...
Need help?
Do you have a question about the TRCCWC and is the answer not in the manual?
Questions and answers