Sendum BT100 User Manual

Introduction
The Bluetooth-enabled Sendum BT100 Smart Probe
tracks payload and ambient temperatures and tilt.
Basic System Operation
Prerequisites
1. PT300D-4G with firmware version of 0.3.07
or higher to support BT100 Smart Probe
connectivity.
2. Advanced Sensor Pack model SP300B or
Accessory Pack model AP310 (each, from here
on, referred to as "pack".)
Link your Smart Probe
1. Connect your PT300D-4G to your pack.
2. Within three seconds of each other, press and
hold the Status Buttons on both your pack and
the BT100 Smart Probe.
3. Release the buttons when the pack Network LED
and the BT100 Smart Probe LED both blink green.
4. If the linking procedure is successful, both the
pack Network LED and the BT100 Smart Probe
LED will switch to steady green for five seconds.
Both devices will subsequently turn their LEDs
off.
5. Refer to "Press and Hold LED Patterns" on page
1 for a description of device LED responses
during this process.
Unlinking
1. Unlinking is not currently supported in trial
versions.
2. Linking to a new BT100 Smart Probe will
automatically unlink the previous Smart Probe.
Verify Operation
To verify proper probe operation, generate a Sensor
Report and check that the following data is reported:
1. Probe temperature
2. Probe ID matching the ID printed on the BT100
Smart Probe label
3. Ambient temperature
4. Tilt
Doc #: TBD - April 2024 © Sendum Corporation. All rights reserved. Sendum is a trademark of Sendum Corporation.
Sendum BT100 Smart Probe
Mounting
Hole (3)
Battery
Compartment
Temperature
Probe
Status Button
Status Button Operation
Press and Release LED Patterns
Once your BT100 Smart Probe is linked with a
PT300D-4G, you can press and release the Status
Button to determine if the temperature sensed by the
temperature probe is within your set thresholds (as
set in Findum Rules or within your own UI).
Activity
Current temperature within
range
Current temperature outside
range
Press and Hold LED Patterns
When linking your BT100 Smart Probe to a PT300D-
4G device by pressing and holding the two devices'
Status Buttons, the following LED patterns are
possible:
Activity PT300-4G
(Network LED)
Looking for link Green blink
partner
Found partner, Green blink
trying to link
Link successful Solid Green
Link failed/no Red fast blink
partner found
User Guide
LED
LED Action
Green blink
Red blink
BT100 Smart
Probe
Blue blink
Green blink
Solid Green
LED off
1