Table of Content 1. Introduction ..................................................1 2. Appearance ................................................... 1 3. Main Features ..................................................2 4. Set up Instruction ................................................. 2 5. Data Report ..................................................3 6. Installation .................................................... 3 7. Important Maintenance Instruction ............................................4 1. Introduction R718PA7 is identified as a LoRaWAN ClassA device and compatible with LoRaWAN protocol. R718PA7 is connected to a RS485 serial of noise sensor and collects noise level to report the data to gateway.
3. Main Features Adopt SX1276 wireless communication module DC 12V adapter supply Noise value detection The base is attached with a magnet that can be attached to a iron object Protection class IP65 Compatible with LoRaWAN Class A ...
5. Data Report The device will immediately send a version package report and then send another report with noise level after 20 seconds. The device sends data by factory default before any configuration is done. ReportMaxTime: 60min (subject to factory settings) Note: Report interval is based on the factory default before shipment.
All of the above suggestions apply equally to your device, battery and accessories. If any device is not working properly. Please take it to the nearest authorized service facility for repair. MiDo Srl FERRARA Via Poledrelli 21 - 44121 (Fe)
Need help?
Do you have a question about the MIDOmet R718PA7 and is the answer not in the manual?
Questions and answers