Page 3
à distance minimum de 20cm entre le radiateur et votre corps. This radio transmitter [IC: 3147A-CL4490] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
CL4490 User Guide Contents CL4490 RF Transceiver ..........................................6 Overview .............................................. 6 Features .............................................. 6 1.2.1 Networking and Security ........................................ 6 1.2.2 Easy to Use ..........................................6 Status LEDs ..............................................7 CL4490 ..............................................7 CL4490-PRO ............................................7 Theory of Operation ............................................8 RF Architecture ..........................................
Scientific, and Medical (ISM) unlicensed band. The radio sustains a standard asynchronous serial data stream between two or more radios out of the box. Housed in a compact and rugged die-cast enclosure, the radio is equipped to replace miles of serial cable using a CL4490 RS232, RS485, or USB interface.
Note: A client’s Link LED lights when in range of the server. It is always lit on a server. Green When flashing, indicates the CL4490 is receiving data. When flashing, indicates the CL4490 is transmitting data. 2.2 CL4490-PRO Figure 2: CL4490-PRO Status LEDs Note: DIP Switches only appear on the CL4490-PRO.
RF Architecture The CL4490 utilizes a server-client network where all clients synchronize their hopping to the server. The server transmits a beacon during the first 1 ms of every hop (20 ms). The client transceivers listen for this beacon; upon hearing it, they synchronize their hopping with the server and the LINK LED illuminates.
CL4490 Security Features In addition to FHSS technology, Ezurio has implemented three levels of security in the CL4490. All three levels associate with their own EEPROM parameter that you may program for permanent operation or change during system operation in volatile memory using on-the-fly commands...
All CL4490 ship with a default rate of 57600 (unless units have been pre-configured to match specific serial settings). If the Interface Baud Rate of the CL4490 unit is changed, the PC Setting Baud Rate must match the device baud rate to allow proper programming of the units.
CL4490 product page. • If any other program that uses the same COM port as the CL4490 is open, close that program and try to read the radio again. If the radio is still unreadable, perform the Force 9600 Baud Recovery.
Page 16
LED blinks because it loses synchronization in the reset. If the client LINK LED is blinking but the server LINK LED is solid, the client is resetting. Resetting units must be replaced. Check for possible buffer overflow in the CL4490. If the host is not using flow control and the 256 •...
Download the AC4490 RF Diagnostic Suite (from the software downloads tab of the CL4490 product page) to analyze the operating band of the CL4490 radios. For further support, contact us at http://www.ezurio.com/contact. 6.1 Force 9600 Baud Recovery To force the serial interface to a known value, follow these steps (this also sets the RF Packet Size and Interface Timeout to default values): Remove power from the radio.
Note: Information furnished by Ezurio in this specification is believed to be accurate. Devices sold by Ezurio are covered by the warranty and patent indemnification provisions appearing in its Terms of Sale only. Ezurio makes no warranty, express, statutory, and implied or by description, regarding the information set forth herein.
CL4490 User Guide 8 Related Documents and Files The following additional CL4490 documents are also available from the CL4490 product page: ConnexLink Product Brief • CL4490 Hardware Integration Guide • Statement of Compliance to EU WEEE Directive and RoHS Directive •...
Ezurio makes no warranties as to non-infringement nor as to the fitness, merchantability, or sustainability of any Ezurio materials or products for any specific or general uses. Ezurio or any of its affiliates or agents shall not be liable for incidental or consequential damages of any kind. All Ezurio products are sold pursuant to the Ezurio Terms and Conditions of Sale in effect from time to time, a copy of which will be furnished upon request.
Need help?
Do you have a question about the CL4490 and is the answer not in the manual?
Questions and answers