Pioneer PD-M60 Operating Instructions Manual

Operating
Instructions
COMPACT DISC PLAYER
PD-VvisO
Thank you for buying this Pioneer product.
Please read through these operating instructions and then you
will know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe
place for future reference.
In some countries or regions, the shape of the power plug and
power outlet may sometimes differ from that shown in the ex-
planatory drawings, however the method of connecting and
operating the unit is the same.
COMPACT
IS\(C5
DIGITAL AUDIO
WARNING: to prevent FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT NOTICE
[For U.S. and Canadian models]
The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed war-
ranty card and keep in a secure area. This is for your security.
[For Canadian model]
CAUTION: to prevent evectric SHOCK DO NOT
USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN
BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
ATTENTION: pour prevenir Les cHocs ELEC-
TRIQUES NE PAS UTILISER CETTE FICHE POLARISEE AVEC
UN PROLONGATEUR UNE PRISE DE COURANT OU UNE
AUTRE SORTIE DE COURANT, SAUF SI LES LAMES PEUVENT
ETRE INSEREES A FOND SANS EN LAISSER AUCUNE PARTIE
A DECOUVERT.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch. U.S., Canadian, European, U.K., and Australian
models are not provided with this switch.
Mains voltages in Saudi Arabia are 127 V and 220 V
only. Never use this model with 110 V setting in Saudi
Arabia.
The line voltage selector switch is located on the rear
panel of this player. Before your player is shipped from
the factory, the switch is set to the power requirements
of the player's destination. Check that it is set properly
before plugging the power cord into the outlet. If the
voltage is not properly set or if you move to an area where
the voltage requirements differ, adjust the selector switch
as follows:
@ Use a medium-sized (flat-blade) screwdriver. Insert the
tip of the screwdriver into the groove of the selector
switch and turn it so that the power voltage marking of
your area points to the arrow.
VOLTAGE SELECTOR
SELECTEUR DE TENSION
"This product is manufactured to comply with the radio in-
terference requirements of EEC Directive 76/889/EEC and
82/499/ EEC."
@) PIONEER'