Table of Contents
Advertisement
Rinse Aid Indicator Setting
•
When your machine is switched off,
press Half Load (½) button (5) and
then On / Off button (1) to switch it
on.
•
Half Load (½) button (5) pressed
and release On / Off button (1).
•
Keep Half Load (½) button (5)
pressed for three seconds more.
•
Rinse Aid Indicator (14) comes on
and the stored rinse aid indicator
status of your machine appears on
the display in the format of "ON" or
"OFF".
•
You can change the status of the
indicator as "ON" or "OFF" with Start
/ Pause / Cancel button (2). If you
switch off the machine with "On/Off"
button (1) when the status is "ON",
then the rinse aid indicator will come
on when the rinse aid level in your
machine becomes low while the
machine is in use. If you switch off
the machine with "On/Off" button (1)
when the status is "OFF", then the
rinse aid indicator will never come
on.
Starting Your Machine
•
Plug the mains plug into the wall
socket.
•
Open the tap.
•
Open the door.
•
Place the dishes.
•
Check if the upper and lower
impellers rotate freely.
•
Put sufficient amount of detergent in
the detergent dispenser and close
its lid.
•
Press On/Off button.
•
Check if the salt and rinse aid
warning indicators (18,14) light and
add salt and/or rinse aid if needed.
•
Determine your washing programme
with the aid of the Programme
Data and Table of Average
Consumption Values.
•
You can select the determined
washing programme by pressing
programme selection button (4).
•
You can see the programme time
in the Remaining Time Indicator
(3).
•
If necessary, you can change your
washing programme as you prefer
by means of the Add Function
Buttons (5,6,7,8).
•
Start the programme by pressing
the Start / Pause / Cancel button
(2).
WARNING:
Pay attention not to open the door of
the machine when it is running. Stop
the machine by pressing Start / Pause
/ Cancel button (2) if you have to open
the door. Then, open the door of your
machine. There may be a rush of
vapor when you open the door of your
machine; be careful. Close the door
and press Start/Pause/Cancel button
(2) again. Programme will resume
running.
•
End of Programme indicator (20 d)
will light up.
•
Turn off your machine by pressing
On / Off button (1).
•
Close the tap.
•
Unplug the mains plug from the
wall socket.
•
Leave your dishes in the machine
for about 15 minutes after they
are washed in order to have them
cooled down. Your dishes will dry
in a shorter time if you leave the
door of your machine ajar during
this period. This will increase
the drying effectiveness of your
machine.
25 GB
Advertisement
Table of Contents
