Summary of Contents for BONHOEFFER BON-P-GI-1.8KW
- Page 1 MONTHS WARRANTY GASOLINE INVERTER GASOLINE WORKSHOP MANUAL BON-P-GI-1.8KW / BON-P-GI-2.1KW/BON-P-GI-2.5KW BON-P-GI-2.9KW/BON-P-GI-3.5KW/BON-P-GI-3.8KW /BON-P-GI-5.5KW/BON-P-GI-7.5KW...
- Page 2 I. Use Security............1 1. Safety rules............7 II. Characteristics and control......6 III. Operating............12 1. Operational checklist........12 2. Commissioning of the generator set..19 3. Connect to electrical devices......24 4. Generator set shutdown......... 27 5. Parallel operation..........28 IV.
- Page 3 Ill. Features and Control (applicable model) Carrying Handle 6 Control Panel Control Panel Fuel Tank Cap 7 Appearance Cover Appearance cover Vent Button 8 Muffler Muffler Spark plug maintenance cover 9 blind Muffler blind window muffler window Recoil starter Control Panel Power Indicator Overload Indicator Operating Indicator...
- Page 4 2. Wiring diagram Kickback start...
- Page 5 Overload indicator 2. Check the air intake (red) looking for impurities and Check Control Parts When the overload is on, Looking for situations indicates that the group Abnormal. Manipulate generator is overloaded and immediately if it is then AC protector works. necessary.
- Page 8 Other viscosities that are shown in the table when the average temperature in your area is within range indicated. Upper limit Room temperature Lower limit Oil Capacity {nominal): d. Fully tighten the View parameters Dipstick. Add the oil and. Dispose of Used Oil in a a.Place the motor in a Waste management...
- Page 9 f. Dispose of Properly c. Attach the oil box used on the any oil used in ground. a management facility of waste approved. d. Remove the dipstick oil and tilt the machine for pouring the Oil Change oil. PRECAUTION Graduated Change the oil when the engine is hot by the operation.
- Page 13 Checking Engine Oil Reinstall the wand measuring machine in the hole; rest on the neck of Place the motor in a level surface oil filling, NO with the Engine stopped. Check Screw the cap onto the hole. the engine oil level. Remove the dipstick Remove the cap from oil again and check the...
- Page 14 PRECAUTION To minimize deposits in its fuel and ensure a Easy start, don't use gasoline left over from the previous season. Electrical appliances Disconnect all electrical devices generator set and turn off the PRECAUTION AC circuit breaker before Start the engine. Let the group Generator cools during The generator set can...
- Page 15 PRECAUTION Turn the switch two in one to the "RUN" position. The Choke Position For start-up may vary according to temperature and others Factors. Turn the savings switch If you start up again A hot engine, of energy to the "ON" position. it's not Need to pull the lever of (Note: Flip the switch the strangler.
- Page 16 When starting the engine, hold the starter handle Recoil and pull slowly until he feels resistance. Then pull quickly to Start the engine. When you throw of the recoil starter, firmly grasp the handle of transport to prevent the generator set falls. WARNING WARNING The boot time of the...
- Page 17 to spin automatically, the WARNING Starter follows hooked, then you can There is a conflict between the Manipulation without Authorization External steering wheel gear will damage the engine and void and the engine sprockets the warranty of the start, and this can cause Damage to the starter.
- Page 18 1. Maintenance Program Stop the generator set before servicing it, disconnect all electrical devices and the battery (if available) equipped) and cool the generator set completely. Serve the generator set in a clean, dry, flat place, to that no accident occurs during the service.
- Page 19 h. Assemble the filter element WARNING in the filter unit i. Mount the clamp The engine does not fill with oil Filter fixation. in the factory. Any operation before it is has filled out correctly with the j. Reinstall the cover type and quantity of recommended of appearance.
- Page 20 f. Carefully screw on the Spark plug plug into the motor with the hand. To. Clean dirt from the Spark Plug Cap and Base g. After the spark plug Spark plug. seated, use a Spark plug wrench for tightening b. Remove the spark plug cap. the spark plug.
- Page 21 c. Remove the screen from the Spark arrestor. d. Carefully remove the Coal deposits Spark Arrestor Display with a wire brush. and. Replace the Spark Arrestor if it is damaged. f. Reinstall the spark arrestors in the muffler and return to Install the blind window of the Silencer.
- Page 22 VIII. Specification Specification Parameter Table Trait Model of motor Style Engine Displacement (cm) 3 parameter Ignition System Startup Style Kickback start Kickback start Oil Capacity (L) Frequency (Hz Voltage (V) Rated Power (kW) Maximum power (kW) Serial Power Factor parameter Insulation rate Fuel Capacity (L) Operating ©...
- Page 23 V. Problem Solving Problem Solution Fault The two-in-one switch is in the Turn the two-in-one switch to the "RUN" position "OFF" position. Fill the fuel tank according to the instructions in this Lack of fuel. manual. Check the oil level. This motor is equipped with a low level of celt sensor.
- Page 24 SCAN VISIT WEBSITE CORPORATE OFFICE...
Need help?
Do you have a question about the BON-P-GI-1.8KW and is the answer not in the manual?
Questions and answers