Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for T-POWER CL5436 Series
Summary of Contents for T-POWER CL5436 Series
- Page 1 User Manual CL5436 Series Integrated AC Charger T-POWER PTY LTD...
-
Page 2: Table Of Contents
User Manual T-POWER PTY LTD Contents 1 Information ..................3 1.1 Copyright ..................3 1.2 Intended Use ................3 1.3 Safety Instructions ..............4 1.4 User’s Responsibilities ............... 6 1.5 Family ..................7 1.6 Product Overview ............... 8 2 Installation ..................12 2.1 Preparations ................ - Page 3 User Manual T-POWER PTY LTD 8.4 Maintenance and Training ............27 9 Disposal ..................28...
-
Page 4: Information
T-POWER PTY LTD. shall not be liable for any direct, special, accidental, indirect damage or any economic consequential damage (including loss of profits). T-POWER PTY LTD. reserves the right to change at any time without prior notice. All rights reserved © T-POWER PTY LTD. -
Page 5: Safety Instructions
User Manual T-POWER PTY LTD be operated. This device is only suitable for charging the following electric vehicles or plug-in hybrid electric vehicles: The charging port is in line with IEC 61851 The charger is in line with IEC 61851 In addition, the following conditions apply to the intended use: The charger must be fixedly installed. - Page 6 User Manual T-POWER PTY LTD Disconnect all power supplies before installing the charger. Failure to do so can result in electric shock, damage to the electrical system and personal injury. Do not remove the circuit protection device or other components until all power supplies are disconnected.
-
Page 7: User's Responsibilities
User Manual T-POWER PTY LTD Always hang the charging plug cable onto the charging plug holder after use. Provide the instructions for the device that a pressure connector (torque wrench) is used for field wiring, indicating the range or nominal value of tightening torque applicable to the connector terminal screws. -
Page 8: Family
User Manual T-POWER PTY LTD 1.5 Family Models without screen Models with screen... -
Page 9: Product Overview
User Manual T-POWER PTY LTD 1.6 Product Overview 1.7.1 Product Parameters Basic Parameters Description Charging mode Mode 3 Charging port IEC61851-1:TYPE 2 Single-phase, 200~240V, 32A, 50~60Hz Input and output ratings Three-phase, 360~420V, 16A/32A, 50~60Hz Single-phase: L1, PE, N Input line... - Page 10 User Manual T-POWER PTY LTD ISO/IEC14443 A Charging protocol OCPP 1.6 (optional OCPP 2.0) Stand-by power Without screen: 5W consumption 3.5/4.3-inch screen: 6W With screen: -25℃~+55℃ Operating temperature Without screen: -30℃~+55℃ Storage temperature -40℃ Relative humidity 5%~95% Length of charging...
- Page 11 User Manual T-POWER PTY LTD 1.7.2 Product Appearance A: 3.5/4.3-inch screen/QR code display area B*: Card swiping area C: Indicator D*: Pole E: Cable protection ring F: Plug socket G: Charging plug *：Optional accessories The appearance shall be subject to the available product. If you do not charge, plug...
- Page 12 User Manual T-POWER PTY LTD 1.7.3 Deliverable Parts Parts Description Charger body Plug socket Screw Cross recessed pan head screw Cross recessed pan head tapping M4*20 screw ST4.2*50 PE plug CN5020-6x40...
-
Page 13: Installation
CL5436 series AC chargers are precision electronic devices. Do not collide or fall when removing from the package and using. Do not use sharp objects to cut or scratch the housing of the charger. - Page 14 User Manual T-POWER PTY LTD It is recommended that a canopy should be added when the charger is installed outdoors, which can reduce the risk of water flooding and extend the service life of the product. Sufficient power access load capacity shall be reserved in the use place of the charger, and the voltage drop and power quality shall conform to the local standards.
- Page 15 User Manual T-POWER PTY LTD Reserve a certain space for installing the charger so that maintenance personnel can inspect and maintain it. 2.1.2 Installation Risk Disclosure The strength of the installation location must meet the requirements, and all the fixing bolts shall be tightened, otherwise there will be a risk of falling and tipping.
-
Page 16: Precautions Before Use
① Recommend location ② Alternative location 2.1.4 Installation For detailed installation procedure, see《Quick Installation Manual for CL5436 Series Charger》. 3 Precautions Before Use After the installation of charger, power on according to the requirements; If the Ethernet connection is used, ensure that the network is normal;... -
Page 17: Instructions
User Manual T-POWER PTY LTD requirements before the device leaves the factory. If the user needs to change the configuration, contact our after-sales engineer for technical support. 3.2 4G Instructions 4G configuration will be carried out according to the user requirements before the device leaves the factory. -
Page 18: Start Charging
User Manual T-POWER PTY LTD disconnected, because there is a risk of electric shock. Please operate the charger in strict accordance with the user manual for the charger, operating instructions and tips on the device, failing which electric shock and fire risk may be caused. - Page 19 User Manual T-POWER PTY LTD Stand-by state Step 2 (Optional) Place the IC card in the card swiping area until the LED indicator is blue. If the single card swiping fails to start for the reason of network problems, proceed with the card swiping process again.
-
Page 20: Stop Charging
User Manual T-POWER PTY LTD 4.3 Stop Charging Step 1 Do not use brute force to pull the mechanically locked plug out of the socket (the users without the card swiping function can skip the card swiping step). Step 2 Pull out the charging plug on the vehicle. - Page 21 User Manual T-POWER PTY LTD Description of abnormal state Abnormality Type Abnormality Indicator Normally on for 2S—>Flash 3 Abnormal voltage times—>Normally on for 2S Normally on for 2S—>Flash 4 Abnormal overcurrent times—>Normally on for 2S Normally on for 2S—>Flash 7 Abnormal overtemperature times—>Normally on for 2S...
-
Page 22: Common Faults
User Manual T-POWER PTY LTD The display screen Normally on for 2S—>Flash 12 communicates times—>Normally on for 2S 6 Common Faults Fault Faults and Troubleshooting Methods Ensure that the power input is properly connected and the power supply is within the... - Page 23 User Manual T-POWER PTY LTD charging time is wear or damage increased Lack of release due to external control devices (power supply device, PV device) The device is damaged, contact the customer service center Fault Ø If the red light does not flash, check the emergency stop status Ø...
-
Page 24: Maintenance
User Manual T-POWER PTY LTD 7 Maintenance To ensure the normal service life of the charger and reduce the risk in use, the charger must be maintained by the professionals using the qualified and safe maintenance tools within the specified time period. -
Page 25: After-Sales Service
User Manual T-POWER PTY LTD Inspection Monthly Trimonthly Semiannually Annually Action Item Charging √ Inspect plug Protection of residual √ Inspect current circuit breaker 8 After-sales Service 8.1 Inspection Methods No. of Item Charger Device Appearance Records Suggestions problem found,... - Page 26 User Manual T-POWER PTY LTD intact, whether relevant staff to repair housing is deformed, fixed or the device; if it cannot rusty repaired, please return to the original factory for repair Inspect whether the charging problem plug is properly plugged,...
- Page 27 User Manual T-POWER PTY LTD after the rain stops If the charging plug is Use a multimeter to measure electrified, please whether the charging plug is inform the relevant staff electrified immediately handling Inspect whether the PG head If the charging cable is 1.10...
-
Page 28: Parts Repair/Replacement
User Manual T-POWER PTY LTD remove dust from the dust screen Inspect whether the interior of Periodically clean the the device is clean dust inside the device Inspection department Inspectors Date of inspection 8.2 Parts Repair/Replacement If the product is damaged or cannot be used normally due to poor... - Page 29 User Manual T-POWER PTY LTD Hotline: 400-808-6233. 9 Disposal The logo is located on the product, in the manual or on the package, indicating that electrical and electronic devices and their accessories shall be disposed separately from ordinary household wastes.
- Page 30 T-POWER PTY LTD Address: F1/ 7 Technology Circuit, Hallam, Victoria, Australia 3803 1300 772 678 t-power.com.au...
Need help?
Do you have a question about the CL5436 Series and is the answer not in the manual?
Questions and answers
Do you have a video showing remote charge or preset timing set charging?