FINDAUTO 168874-5332-1702546391 Manual

The overview of tire pressure sensor learning methods. The types of learning methods are
divided into A, S, O, A/O, S/O, A/S/O, and C.
Introduction to learning methods:
1. "A" stands for self-learning mode
Learning steps:
1-1. Install the tire pressure sensor correctly
1-2. Adjust the tire pressure of all tires to the standard value (the manufacturer's nominal value
mark is located at the lower position of the door frame of the driver's seat)
1-3. The vehicle remains in a completely stationary state for more than 20 minutes (ignition and
power off)
1-4. Drive at a speed of 30-100 km/h for more than 15 minutes
1-5. The vehicle will automatically learn the new sensor information, and the tire pressure
warning will disappear after the learning is successful (if the tire pressure data can be showed on
the vehicle, the real-time tire pressure data will be displayed). If learning fails, please repeat steps
2-5
2. "S" stands for static learning mode
Learning steps:
2-1. Install the tire pressure sensor correctly
2-2. Pull up the parking brake
2-3. Turn the ignition switch to the energized position (engine off)
2-4. Enter the tire pressure learning mode through the vehicle dashboard. There will be
corresponding prompts on the dashboard (the method of entering the tire pressure learning
mode for each brand model will be different, please refer to the vehicle manual or consult a
professional)
2-5. Starting from the left front wheel (some models will have the corresponding position turn
signal flashing), use the activation tool (Daotong, Yuanzheng, etc.) to activate the tire pressure
sensor. If the activation is successful, the vehicle will have a whistle or a steering corresponding
to the sensor position being learned The light flashes.
! Note: The first sensor should be learned within 2 minutes, otherwise please repeat step 4
2-6. After learning the left front wheel sensor successfully. For the remaining positions, please
activate the remaining tire pressure sensors in the order of front right, rear right, and rear left.
The activation prompt and activation success status are the same as step 5.
! Note: The remaining sensor learning needs to be completed within 3 minutes, otherwise please
skip back to step 4 and repeat the sequence operation
2-7. Transfer the vehicle to the flame-out and power-off state. Adjust the tire pressure of all tires
according to the standard value of tire pressure (the manufacturer's nominal value mark is
located at the lower position of the door frame in the driving position)
2-8. After the learning is successful, the tire pressure warning will disappear (if the tire pressure
value is supported, the real-time tire pressure data will be displayed). If learning fails, please
repeat steps 4-7
3. "O" stands for OBD learning mode
Learning steps:
3-1. Need a tire pressure activation device (Dutong Yuanzheng, etc.)
3-2. Correctly install tire pressure sensor