Tranquility Bathroomware BHC Manual

whisper bathroom heaters
Whisper Wall Fan Heater
The Whisper Wall Fan Heater is a metal bodied heater ideal
for bathrooms, kitchens and areas requiring localised,
controllable heat. The Whisper features a variable thermostat,
with a frost protec�on se�ng for increased economy,
pull-cord opera�on, automa�c overheat safety cut-out and an
indicator light. For ease of installa�on, it is fi�ed with a 0.9m
cable.
Features:
Thermosta�c control • Pull-cord opera�on • Automa�c safety
cut-out • Fi�ed power supply cable • Fixing / Securing bracket
• Finished in crisp white or stainless • 190h x 115d x 300w mm
Note: The indicator light is on un�l the desired temperature
is reached.
Safety
This heater has been designed and manufactured to the highest interna�onal standard, but, like all other electrical
appliances which are operated by mains voltage, care must be taken if you are to obtain the best results and safety
is to be assured.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabili�es, or lack of experience and knowledge, unless they have been given supervision or instruc�ons
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The heater is to be installed so that switches and other controls cannot be touched by a person in the bath or
shower.
The heater must not be installed in front of a socket-outlet.
Means for disconnec�on must be incorporated in the fixed wiring in accordance with the wiring rules.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Do not handle the appliance with wet hands.
Do not use the appliance in workshops or rooms where excessive dust is generated or present.
Ensure that nothing is pushed into any aperture of this appliance.
Do not touch the outlet grill when the appliance is in use.
Installa�on
Ensure that the electricity supply is disconnected from any relevant fixed wiring before commencing
the installa�on. Ensure that the mains supply voltage is as stated on the ra�ng label. The supply circuit
must be adequate for the input of the appliance. This unit must be installed by a registered electrician.
The installa�on of this product must comply with NZS 3000.2007.
• The appliance should be fi�ed horizontally such that the cable entry is uppermost and the pullcord is at the
bo�om.
• The unit must be mounted a minimum of 1.8m from the floor, also a minimum of 150mm below ceiling level or
any other projec�ng surface. It must also not be less than 250mm from any adjacent projec�ng surface.
• The unit must not be located immediately below a fixed socket outlet.
• Ensure that when in use the airstream is not obstructed by a cupboard or similar object.
• Do not a�empt to repair the heater or unscrew the outer casing yourself.
• Do not place aerosols or similar containers or materials suscep�ble to heat in the direct airstream.
• Isolate the heater from the mains power supply. A suitable disconnection device is required when installing.
bathroomware
Thermostat
Control Knob
Outlet
Grill
Inlet Grill
Switch
Pullcord