LITETRONICS TR01 Operation Instructions

Test Remote for LED fixtures with integrated EBB
Operation Instructions
Part # TR01
Instructions for Remote Control
Please note: Remote must be pointed at red indicator light and be within a 45 degree angle to
receive a signal/command. Remote needs two AAA batteries to operate (not included).
Testing: To test emergency functionality, press the TEST/+ button. The light will switch to its
emergency state for 3 seconds and the indicator light will flash red. After 3 seconds, the fixture will
return to normal operation.
Demonstration: To demonstrate the emergency functionality, start with the fixture powered on
and in normal operation. Press the DEMO button, then press the On/OFF button. The fixture will
switch to it's emergency state. Repeat this operation and the fixture will return to normal operation.
For use with LED Light Panel (PTEM Series)
The red indicator light on the LED Light Panel is located behind the lens and will only be visible when
in emergency or test mode.
4/10/23 - V2.1
Button # 1 (Test/+)
Button # 2 (Demo/-)
Button # 3(On/Off)
EBB UNIT
1